Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Crescent BA611 BA 551D
Summary of Contents for Crescent BA611 BA 551D
- Page 1 BA611 Operator manual – English www.crescentindustrial.co.uk...
-
Page 2: Table Of Contents
USER MANUAL ENGLISH TABLE OF CONTENTS INTRODUCTION ................................2 MANUAL PURPOSE AND CONTENTS ............................2 TARGET ......................................2 HOW TO KEEP THIS MANUAL ............................... 2 DECLARATION OF CONFORMITY ..............................2 IDENTIFICATION DATA ................................... 2 OTHER REFERENCE MANUALS ..............................3 SPARE PARTS AND MAINTENANCE ............................. 3 CHANGES AND IMPROVEMENTS .............................. -
Page 3: Introduction
ENGLISH USER MANUAL INTRODUCTION NOTE The numbers in brackets refer to the components shown in Machine Description chapter. MANUAL PURPOSE AND CONTENTS The purpose of this Manual is to provide the operator with all necessary information to use the machine properly, in a safe and autonomous way. -
Page 4: Other Reference Manuals
USER MANUAL ENGLISH OTHER REFERENCE MANUALS Electronic Battery Charger Manual (if equipped), to be considered as integral part of this Manual Moreover, the following Manuals are available: – Service Manual (that can be consulted at Nil sk Service Centers) – Spare Parts List (supplied with the machine) SPARE PARTS AND MAINTENANCE All necessary operating, maintenance and repair procedures must be performed by quali ed personnel or by Nil sk Service... -
Page 5: Safety
ENGLISH USER MANUAL SAFETY The following symbols indicate potentially dangerous situations. Always read this information carefully and take all necessary precautions to safeguard people and property. The operator’s cooperation is essential in order to prevent injury. No accident prevention program is effective without the total cooperation of the person responsible for the machine operation. - Page 6 USER MANUAL ENGLISH WARNING! – Carefully read all the instructions before performing any maintenance/repair procedure. – Before using the battery charger, ensure that frequency and voltage values, indicated on the machine serial number plate, match the electrical mains voltage. – Do not pull or carry the machine by the battery charger cable and never use the battery charger cable as a handle.
-
Page 7: Machine Description
ENGLISH USER MANUAL MACHINE DESCRIPTION MACHINE STRUCTURE Control panel Machine straight forward movement adjusting handwheel Handlebar Machine forward speed adjusting handwheel (***) Drive paddle (*) 30a. Recovery tank cover (opened to be cleaned) Drive speed adjuster (*) 30b. Recovery tank cover (completely opened) Battery charger data inspection window (optional) Tank cover gasket Battery charger cable (optional) - Page 8 USER MANUAL ENGLISH 55 13 26 15 S311310 BA 551 - BA 551D - BA 551CD - BA 611D 909 6752 000(3)2010-03 A...
-
Page 9: Control Panel
ENGLISH USER MANUAL CONTROL PANEL Brush/pad-holder and vacuum system switch 81a. Charged battery warning light (green) Brush/pad-holder and vacuum system switch warning light 81b. Semi-discharged battery warning light (yellow) Vacuum system switch 81c. Discharged battery warning light (red) Vacuum system switch warning light Solution ow control switches Brush/pad-holder release switch (*) 82a. -
Page 10: Accessories/Options
USER MANUAL ENGLISH ACCESSORIES/OPTIONS In addition to the standard components, the machine can be equipped with the following accessories/options, according to the machine speci c use: GEL batteries Electronic battery charger Brushes and cylindrical brushes of different materials Pads of different materials Polyurethane squeegee blades EcoFlex™... - Page 11 ENGLISH USER MANUAL Technical data for machines with brush/pad-holder deck BA 551 BA 551D BA 611D 1 brush/pad-hold- 1 brush/pad- 2 brushes/pad- Model er, without drive holder, with drive holders, with drive system system system Cleaning width 530 mm 530 mm 610 mm Squeegee width 760 mm...
-
Page 12: Wiring Diagram For Ba 551
USER MANUAL ENGLISH WIRING DIAGRAM FOR BA 551 Colour codes 24 V battery Black Battery connector Blue Battery charger connector Brown Battery charger (optional) Green Deck connector Grey Function electronic board Orange Brush motor electromagnetic switches Pink Vacuum system relay Water solenoid valve Violet Deck fuse... -
Page 13: Wiring Diagram For Ba 451D And Ba 531D
ENGLISH USER MANUAL WIRING DIAGRAM FOR BA 451D AND BA 531D Colour codes 24 V battery Black Battery connector Blue Brown Battery charger connector Battery charger (optional) Green Cylindrical brush deck secondary connector Grey Function electronic board Orange Drive system electronic board Pink Brush motor electromagnetic switches Vacuum system relay... -
Page 14: Use
USER MANUAL ENGLISH WARNING! On some points of the machine there are some adhesive plates indicating: – DANGER – WARNING – CAUTION – CONSULTATION While reading this Manual, the operator must pay particular attention to the symbols shown on the plates. Do not cover these plates for any reason and immediately replace them if damaged. -
Page 15: Battery Installation And Battery Type Setting (Wet Or Gel)
ENGLISH USER MANUAL BATTERY INSTALLATION AND BATTERY TYPE SETTING (WET OR GEL) Set the electronic board of the machine and of the battery charger (if equipped) according to the type of batteries installed (WET or GEL) as shown below: Machine setting (only for BA 551) Press the switch (71) or (73) and pay attention to the following in the very rst seconds of machine operation: •... -
Page 16: Before Machine Start-Up
USER MANUAL ENGLISH BEFORE MACHINE START-UP Deck installation/removal The machine can be equipped with either the brush/pad-holder deck (18a and 18b) or the cylindrical brush deck (18c). For deck installation/removal see the procedure in Maintenance chapter. NOTE When the deck is installed/removed, it may be necessary to change the squeegee too, because they must have the same width. - Page 17 ENGLISH USER MANUAL Available brushes and their relevant application guides (suggestions only) General cleaning: Concrete Terrazzo oor Ceramic tiles/quarrystones Marble Vinyl tiles Rubber tiles Polishing: Rubber tiles Marble Vinyl tiles Cylindrical brush installation/removal (only for BA 551CD) Turn the ignition key (80) to “0”. Lift the cylindrical brush deck by pressing the pedal (11).
- Page 18 USER MANUAL ENGLISH Squeegee installation Install the squeegee (25) and fasten it with the handwheels (26), then connect the vacuum hose (15) to the squeegee. With the handwheel (27), adjust the squeegee so that the rear blade - in all its length - touches the oor and the front blade is slightly detached from the oor.
-
Page 19: Machine Start And Stop
ENGLISH USER MANUAL MACHINE START AND STOP Starting the machine Prepare the machine as shown in the previous paragraph. (Only for BA 551D, BA 551CD, BA 611D): Turn the ignition key (80) to “I”. (Only for BA 551): Turn on the machine by pressing the switch (71) and/or (73). Check that the green warning light (81a) turns on (charged batteries). - Page 20 USER MANUAL ENGLISH Adjustment of the detergent concentration in the solution (For machine with EcoFlex™ system) The system used to mix the detergent with the washing water can be activated by pressing the detergent ow control switch (A, Fig. 5): when the led indicator (B) is ON, the detergent is added to the washing water. The display (C) shows the detergent concentration level (1 to 6) in the solution: for the related percentage values refer to the table (D).
-
Page 21: Tank Emptying
ENGLISH USER MANUAL Working with brush/pad-holder extra pressure function turned on If the oor proves to be particularly dif cult to clean, it is possible to turn on the brush/pad-holder extra pressure function by pressing the pedal (11) to position (11c). CAUTION! When the cylindrical brush deck (18c) is installed, the extra pressure function is not enabled. -
Page 22: After Using The Machine
USER MANUAL ENGLISH AFTER USING THE MACHINE After working, before leaving the machine: Remove the brushes/pad-holders according to the procedure shown in the relevant paragraph. Empty the tanks (20 and 21) and the debris container (D, Fig. 3) as shown in the relevant paragraph. Perform the daily maintenance procedures (see the Maintenance chapter). -
Page 23: Battery Charging
ENGLISH USER MANUAL BATTERY CHARGING NOTE Charge the batteries when the yellow or red warning light (81b or 81c) turns on, or at the end of every working cycle. CAUTION! Keeping the batteries charged make their life last longer. CAUTION! When the batteries are discharged, charge them as soon as possible, as that condition makes their life shorter. -
Page 24: Machine Working Hour Check
USER MANUAL ENGLISH Battery charging with (optional) battery charger installed on the machine Connect the battery charger cable (6) to the electrical mains (the electrical mains voltage and frequency must be compatible with the battery charger values shown on the machine serial number plate (34)). When the battery charger is connected to the electrical mains, all machine functions are automatically cut off. -
Page 25: Squeegee Blade Check And Replacement
USER MANUAL ENGLISH SQUEEGEE BLADE CHECK AND REPLACEMENT Clean the steel squeegee (Fig. 6) or the aluminium squeegee (Fig. 7), according to the procedure shown in the previous paragraph. Check that the edges (E, Fig. 6 or 7) of the front blade (C) and the edges (F) of the rear blade (D) lay down on the same level, along their length;... -
Page 26: Brush/Pad Cleaning
USER MANUAL ENGLISH BRUSH/PAD CLEANING CAUTION! It is advisable to wear protective gloves when cleaning the brushes/pads/cylindrical brushes because there can be sharp debris. Remove the brushes/pads from the machine, as shown in the Use chapter. Clean and wash the brushes/pads with water and detergent. Check the brushes/pads for integrity and wear;... -
Page 27: Vacuum System Motor Filter Cleaning
ENGLISH USER MANUAL VACUUM SYSTEM MOTOR FILTER CLEANING Drive the machine on a level oor. (Only for BA 551D, BA 551CD, BA 611D): Turn the ignition key (80) to “0”. (Only for BA 551): Turn off the machine by pressing the switch (71) and/or (73). Open the recovery tank. -
Page 28: Fuse Check/Replacement
USER MANUAL ENGLISH CLEAN WATER FILTER CLEANING (For machine with EcoFlex™ system) Drive the machine on a level oor. Turn the ignition key (80) to “0”. Open the cover (22) and check that the recovery tank (21) is empty, otherwise empty it with the drain hose (16). Grasp the handle (41) and carefully lift the tank (40). -
Page 29: Brush/Pad-Holder/Cylindrical Brush Deck Disassembly/Assembly
ENGLISH USER MANUAL BRUSH/PAD-HOLDER/CYLINDRICAL BRUSH DECK DISASSEMBLY/ASSEMBLY The machine can be equipped with either the brush/pad-holder deck (18a and 18b) or the cylindrical brush deck (18c). NOTE When the deck is installed/removed, it may be necessary to change the squeegee too, because they must have the same width. -
Page 30: Detergent Tank Cleaning
USER MANUAL ENGLISH DETERGENT TANK CLEANING (For machine with EcoFlex™ system) Clean the detergent tank (45) according to the following procedure: Drive the machine to the appointed disposal area. Open the cover (22) and check that the recovery tank (21) is empty, otherwise empty it with the drain hose (16). Close the cover (22). -
Page 31: Troubleshooting
USER MANUAL ENGLISH TROUBLESHOOTING The motors do not work; no warning light turns The battery connector is disconnected. Connect. The batteries are completely discharged. Charge the batteries. The machine does not move The machine has been turned on by using the Turn the ignition key to “0”, then try to start the (Only for BA 551D, BA 551CD, BA 611D) ignition key and by keeping the paddle pressed. - Page 32 We supply a full range of cleaning equipment for rental or purchase. For more information, or a cleaning solution to suit your business, please get in touch – For a more comprehensive product range, please visit our website. Address Contact Berrington House, t: 0845 33 77 695 Berrington Road,...
Need help?
Do you have a question about the BA611 BA 551D and is the answer not in the manual?
Questions and answers