Table of Contents
Advertisement
Page 49
AC 206-226
B. ICEMAKER
The following maintenance should be scheduled
at least two times per year on these icemakers.
1 .
Check and clean the water line strainer.
2.
Check that the icemaker is levelled in side to
side and in front to rear directions.
3.
Clean the water system, evaporators, bin
and spray bar/s using a solution of SCOTSMAN
Ice Machine Cleaner.
Refer to procedure C cleaning instructions and
after cleaning will indicate frequency and proce-
dure to be followed in local areas.
4.
Reach the water spray bar from the inside of
the freezing chamber lifting it from its seat with its
bottom race washer.
FIG. 8
- EVAPORATOR
- CONDENSER
Rx
Tx
L
N
16
DIP
SWITCH
ELECTR.
15
TIMER
13
1
TRANSF.
2
Dip it into a tray filled with cleaning solution then
rinse it under a tap water stream.
With a pick clean the orifice of the water stream
jet that propells the spray bar.
NOTE. Cleaning requirements vary according
to the local water conditions and individual
user operation. Continuous check of the clarity
of ice cubes and visual inspection of the
water spraying parts before and after cleaning
will indicate frequency and procedure to be
followed in local areas.
5.
With the ice machine and fan motor OFF on
air cooled models, clean condenser using vacuum
cleaner, whisk broom or non metallic brush taking
care to do not damage both the condenser and
ambient temperature sensor probes.
7
8
9
10
RELAYS
3
4
5
TRIAC
6
RELAY
11
12
Page 49
WATER DRAIN VALVE
WATER IN VALVE
HOT GAS VALVE
COMPRESSOR
FAN MOTOR
WATER PUMP
ELECTRONIC CARD
Hide quick links:
Advertisement
Table of Contents
