Advertisement
Inflatable 3 Stack Pumpkin
Contents:
A.
Main unit with
power cord X1
Instructions:
Step 1.
Carefully unpack your
material until all parts of the unit have been found.
Step 2.
Place Inflatable 3 stack pumpkin on a clean, open area, free from obstruction or debris.
Step 3.
Roll out fabric and lay out the all the parts. Make sure the air intake located on the bottom of
unit is clear of fabric and free of obstruction.
Step 4.
Fully close the zipper on the bottom of the unit.
Step 5.
Tie the clips on one end of tethers, attach the clips to the rings on both sides of the unit.
Step 6.
Secure the four tent-stakes into ground, attach the one end of the two tethers and two rings on
bottom of the unit to the tent-stakes.
Step 7.
To inflate product, plug the unit into a mains power outlet socket.
Step 8.
To deflate product, unplug the cord from the electrical outlet and unzip the unit.
B.
C.
Rope X2
Clip X2
Inflatable 3 stack
pumpkin. Make sure you do not discard any packaging
D.
Tent-stake X4
Advertisement
Table of Contents
Related Manuals for anko RKPO-AU1200600IP44-1
Summary of Contents for anko RKPO-AU1200600IP44-1
- Page 1 Inflatable 3 Stack Pumpkin Contents: Main unit with power cord X1 Rope X2 Clip X2 Tent-stake X4 Instructions: Step 1. Carefully unpack your Inflatable 3 stack pumpkin. Make sure you do not discard any packaging material until all parts of the unit have been found. Step 2.
- Page 2 Input Rated Output Rated Model No. Voltage Frequency Current Voltage Power RKPO-AU1200600IP44-1 100-240VAC 50-60Hz 0.30A Max 12V AC 7.2W Do not open the cover of the equipment’s. For use with LED lighting equipment. The input and output voltage should be checked before use to ensure correct use.
- Page 3 These instructions are for your safety. Please read through them thoroughly before use and retain for future reference. Before You Start • Decide on an appropriate location for your product (see Installation instructions below). • If you have any doubt about installing this product, consult a qualified electrician. Installation instructions: This inflatable product is suitable for INDOOR AND OUTDOOR USE.
- Page 4 • Care must be taken to avoid damage the cable or fittings. • If any part of light set or cable is damaged, the light set MUST be discarded. • This product is for use as a decoration only. Not to be used by children as a toy. Keep out of reach of children.
Need help?
Do you have a question about the RKPO-AU1200600IP44-1 and is the answer not in the manual?
Questions and answers