BEINAT FS230M Manual

Flashing Siren "System Gas"
The new Flashing Siren " FS Series" is born from the elegance and prestige that has always distinguished
BEINAT S.r.l.
The siren is built in three models: FS230M - FS012M - FS024M. This device has the prerogative to signal, through
the audio group and of the flashing light incorporated, the presence of danger.
The sirens can have various supply:
FS230M; 230/240 VAC 50/60 Hz AC Supply
FS012M; 12 VDC Supply
FS024M; 24 VDC Supply
This device has 2 microswitch through which the user can select:
1) a flashing only device. With this feature the audio part is deactivated.
2) a timer to turn off the audio part in order to avoid noise pollution. While the audio is off the light flash will
continue until the alarm is active.
The external case is in ABS plastic with a IP54 protection.
Important: Assembly / maintenance of the appliance must be carried out by qualified personnel and in
accordance with applicable laws and regulations.
The manufacturer assumes no responsibility for the use of products that have to comply with particular
environmental and / or installation standards.
Important note
Before connecting the equipment, it is recommended that you read the instruction manual carefully and
keep it for future reference. It is also recommended to perform the electrical connections correctly as
per enclosed drawings, observing the instructions and the Standards.
N.B. Refer to the documentation in all cases where the symbol is on the side

Installation and
user guide
INSTALL IN SAFE
AREA, NO ATEX
Electric connections also available on
FS230M - FS012M - FS024M
CONFORMITY
IEC 61010-1
Reports issued by TUV Italia
Channel: Beinat gas solutions
Beloging to
V1
EN 50270
EN 5423