Advertisement
NOTE:
• All the adjustments
for the
operation of the laser guide has
been completed at the factory.
• Laser beam is calibrated and set
up to project to the left of the blade,
(Fig. Y)
• tf you have any problem or
question on the laser guide, please
call the Sears Service Center,
Fig. Y
(
'_
_
cutting tine
laser beam
workpiece
/
laser beam
top
_--_"""
blade
II""-_
cutting line
riew
AVOID DIRECT EYE CONTACT
I_
WARNING
1
+ Laser is radiated when laser
guide is turned on, Avoid direct
eye contact, Always un-plug the
miter saw from power source
before making any adjustments,
(Fig. Z)
Laser Aperture Label:
AVOID EXPOSURE:
Laser
radiation is emitted from this
aperture. (Fig. Z)
i AVOID EXPOSURE
L.s_r m 0ia_a. A
1 }
is emitted from
I,++o+
l_
WARNING]
•
Use of controls or adjustments
or performance
of procedures
other than those specified herein
may result in hazardous radiation
exposure.
_IL WARNING I
+ The use of optical instruments
with this product will increase
eye hazard.
•
Do not attempt to repair or
disassemble the laser.
If unqualified persons attempt to
repair this laser product, serious
injury may result. Any repair
required on this laser product
should be performed by a Sears
or other qualified service center.
NOTE: All the adjustments for the
operation of this machine have been
completed at the factory.
Mg. Z
IA
DANGER I
•
Laser Warning Label:
Max output < 5 mW DIODE
Wavelength:
630-660nm,
Complies with 21CFR 1040,10 and
1040, 11.
Laser
Warning
Label
Laser
Ape_ure
Label
....
29
Advertisement
