Table of Contents
Advertisement
Quick Links
Analog effect unit that has both memory and recall
functions for all possible settings;
This allows the artist to configure the effect for the
preferred sounds via the 15 parameters.
It is a step up for the analog guitar effects as it
introduces an analog-digital architecture that
works in the analog domain and that is controlled
by a digital processor.
The memorized settings can be recalled via the two
footswitches, CNT1 and CNT2, or via a MIDI
connection.
These 2 important characteristics, digital control,
and remote MIDI control, make it one of the most
innovative guitar effect within the market.
A preset is composed of the 15 parameters, each
preset can be memorized using the
pushbutton; keep pressed until the "WR" appears
on the display.
A 10 preset memory is available.
A maximum of ten presets can be saved; you can recall them
sequentially, using the footswitch CNT2.
Press the CNT1 to toggle the BYPASS and the selected preset,
press the CNT2 to change the preset up and down.
Keep pressed the CNT2 to go back into the preset sequence.
Beyond the ordinary
PARAMETERS
MIDI
interface.
15 adjustable parameters are available:
All the parameters can be adjusted using the
LEVEL and PARM knobs; using the PARM knob you
SET
can select the parameter you wish to modify, using
the LEVEL knob you can set the value of the
selected parameter.
CUT : 005%
<
FDB : 065%
MIX : 050%
LEV : 080%
There are 3 parameter pages: the DELAY, the
Chorus and the "Routing/Tone" pages.
Every page contains the parameters
associated to the 3 parts of the effect: the
Delay, the Chorus and the "routing and tone"
unit.
SNAKE
SET
LEVEL
PARM
1
Advertisement
Table of Contents
Summary of Contents for Medea SNAKE
- Page 1 Beyond the ordinary SNAKE Analog effect unit that has both memory and recall PARAMETERS MIDI functions for all possible settings; interface. 15 adjustable parameters are available: This allows the artist to configure the effect for the preferred sounds via the 15 parameters.
- Page 2 DELAY ROUTING and TONE OUT: which types of signals you send through the The first row shows the delay time, you can set it A and B outputs using the LEVEL knob, step=1mS; to set large delays use the TAP sequence, then adjust the time OutA: Delay OutB: Chorus you want using the LEVEL knob.
- Page 3 SERVICE & WARNING When in delay page, keep pressing CNT1 for at least 3 seconds; a “TTT” will appear, Always refer to a qualified personnel when then press the CNT1 footswitches at the servicing is required. Don’t expose the effect to time rate you want.
Need help?
Do you have a question about the SNAKE and is the answer not in the manual?
Questions and answers