Table of Contents
Advertisement
OPERATING THE TELEVISION RECEIVER
TO SWITCH ON THE RECEIVER
Push in the POWER switch. POWER indicator will be illuminated.
Note:
If the power stays in standby mode, push the
AY
buttons.
TO ADJUST VOLUME
(A W ) 4
CHANNEL SELECTION
AND TUNING
(A W)
You can select your. favourite program by the channel selection keys on the remote control hand unit or "CHANNEL
UP/
DOWN" keys on the front of the receiver.
To enjoy the program which is not preset, set the channel by following procedure.
(1) CHANNEL PRESET PROCEDURE
Select the position to be preset by the Channel Position Button (& or W ) on the TV set or the remote control hand unit
or by the Direct Position Selector on the remote control hand unit.
To select a position from
10 to 29, press either the ''1—'' or ''2—" button first, and then press one of the buttons from
"0" to 9",
For example:
16th. position; Press the ""1—"' and "6" buttons.
29th. position; Press the ''2—"' and ''9'' buttons.
(2) SEARCH
a. Push on the tuning mode switch, ( [ee] (*))
. Push the SEARCH key.
When television signal is caught, search operation stops and the channel is memorized automatically.
. During search operation, '' >>> " is indicated under the position indication.
. When SEARCH gets to the END of VHF or UHF, the display " >>> " will flash.
oooen
(3) MFT (Manual Fine Tuning)
a. Push off the tuning mode switch. (e->(#))
b. Tune the fine picture by MFT button. (A or W)
AUTO PRESET
MSSS (Multi Spacial Sound System) Button ( G®
)
Advertisement
Table of Contents
