What Happens In Each Cycle; Self-Cleaning Lint Filter - KitchenAid KAWE770B Use And Care Manual

Operating Your Washer
What happens in each cycle
When the Cycle Control Knob is turned to a After agitation starts, the Cycle Control Knob
setting and pulled out, the washer fills (tothe turns clockwise until it points to OFF and the
selected load size) before agitation and cycle ends.
timing start. The washer begins agitating The washer pauses briefly throughout
immediately after filling; agitation can occur each cycle. These pauses are normal for
with the washer lid up or down. washer operation.
WASH RINSE
cs Fill Fill
wy wy
Rinse
yy
Wash*
~~
*Wash agitation speed Is reduced in the last few
minutes of most cycles. This provides better fabric care.
_m..| Drain (or partial drain*)
sy lo agitation
ww
* For cool down, the Permanent Press cycle partially
drains, fills, agitates briefly, and drains.
Spin
ww
Self-cleaning lint filter
Your washer has a self-cleaning lint fitter at
the bottom of the washer basket. During
agitation, wash and rinse water pass over
the filter, separating the lint from the water.
The lint is then spun away from the filter and
out of the system during the spin part of
Drain-No agitation
> A
Spin-Spray rinse
= |e |e | lar
(
the cycle. 2
If your washer drains into a tub, remove Self-cleaning Bask
any lint collected in the tub or strainer. lint fitter interior
10