Classic Exhibits visionary DESIGNS MOD-1331 Setup Instructions

© 2023
Order #XXXXX

Steps:

1) Attach lower verticals [2] and [3] to base plate [1], using bolts.
2) Attach upper vertical [4] to lower vertical [2], using connector.
3) Attach shelves to vertical [2].
4) Attach large graphic to verticals [3], using screw caps.
See Large Graphic Attachment detail.
5) Attach flange plates [5] to tops of verticals [3], using bolt.
6) Attach counter to flange plates [5] vertical [2],
and thumb screws. See Counter Attachment
7) Attach small and curved graphics to [4], using A10 clamps.
See A10 Clamp detail.
8) Attach monitor mount to [4]. See Monitor Mount
*
Large Graphic
Attachment
V4
Graphic
Z45
Screw
Cap
Slide V4 into Z45 then tighten set screw.
Secure graphic to V4, using screw cap.
*
Counter Attachment
Counter
Fixed
Screws
3
Flange
3
Plate [5]
Wing Nut
Attach flange plates to extrusions [4], using
screws. Insert fixed screws, on counter, into
holes of flange plate then secure with wing
nuts. Secure back of counter, using thumb
screws.
MOD-1331 Workstation
using wing nuts
detail.
A10
Clamp
detail.
4
Keep A10 clamps attached
to [4] when packing.
Keep connector with set
screws attached to [2]
Connector
when packing.
2
3
3
Large
Graphic
Screw
Cap
1
Item Qty.
1 1
*
A10 Clamp
2 1
3 2
Tighten set screw to
4 1
secure A10 to [4].
5 2
-- 3
Tighten knob to secure
graphic to A10 Clamp.
Shelf
Shelf
Shelf
3
3
2
*
SETUP INSTRUCTIONS
If you would like to tell us about your experience with your setup instructions please email us at info@classicexhibits.com
Description
Base Plate
48" Q914 Vertical Extrusion
38" Z45 Vertical Extrusion
25" Q914 Vertical Extrusion w/ Cap,
Clamps, and Connector
Flange Plate
Shelf
Small
Graphic
* Curved
*
Graphic
*
*
Counter
Monitor Mount Attachment
Attach Monitor Mount back piece to
vertical extrusion using bolts & nuts.
5
Thumb
5
Screw
Bolts
Monitor Mount
Back piece
Slide connectors into groove of extrusion. Tighten
set screws to secure connectors in place. Attach
monitor mount back plate to extrusion, using bolts.
Completed Assembly
*
V4
Connectors
Slide monitor mount
into back piece.