Advertisement
Quick Links
1
Overview
You can always find the latest version of this
build
manual
on
achordion-build-manual.pdf.
This kit contains a printed circuit board (PCB) with
all the surface mount device (SMD) parts already pre-
soldered. The through-hole components are left to be
assembled by you.
Pay attention to the orientation and position of all
the parts. Desoldering them would be difficult and
may break the module. Also, be careful not to touch
the pre-soldered SMD parts with the soldering iron.
Read through the whole manual first. Make sure you
understand all the steps before you start soldering.
Achordion – Build Manual
https://zlosynth.com/
2
Tools required
• Soldering iron
• Masking tape
• Small flat head screwdriver
• Side-cutters
Advertisement
Summary of Contents for zlosynth instruments Achordion
- Page 1 Achordion – Build Manual Overview Tools required • Soldering iron You can always find the latest version of this build manual • Masking tape https://zlosynth.com/ achordion-build-manual.pdf. • Small flat head screwdriver This kit contains a printed circuit board (PCB) with •...
- Page 2 Bill of materials Start by unpacking all baggies into a bowl so you don’t lose any components. 1 × Front panel 1 × PCB (the black board) 1 × Daisy Patch Submodule (the yellow board) 4 × Potentiometer, M7 nut and washer 1 ×...
- Page 3 Front panel Now when all the internal parts are soldered, the next step would be to assemble parts sitting in the front panel. 1. Snap in the button. Take care not to bend its leg. Don’t push the button all the way to the PCB. See figure 4.
- Page 4 Final assembly Connect the Daisy Patch Submodule to the main black PCB to complete the build. Congratulations The module is now complete. Have fun! You can find the user manual on https://zlosynth. com/achordion-user-manual.pdf. Figure 8: Front view of the assembled module...