Advertisement
Available languages
Available languages
12
EXPANSION CARD X-DANTE
5.4 X32 with X-DANTE connection to
Midas PRO2 via DN9650 + CM1 Dante card
Midas Console
Cat 5/6 AES50
@ 96 kHz
24 x 24 channels
Klark Teknik DN9650
Router/Switch
Laptop
for con guration
routing and mixer
remote control
Network of Dante-enabled equipment
VIEW
VIEW
VIEW
VIEW
VIEW
VIEW
VIEW
VIEW
VIEW
VIEW
– 6
10
10
10
5
5
5
VIEW
0
0
0
– 5
– 5
– 5
–10
–10
–10
– 20
– 20
– 20
– 30
– 30
– 30
– 40
– 40
– 40
– 50
– 50
– 50
– 60
– 0 0
– 60
– 0 0
– 0 0
– 60
Behringer X32
with X-DANTE
Cat 5/6 Ethernet
@ 48 kHz Dante
32 x 32 channels
Cat 5/6 Ethernet,
Dante network @48 kHz
5.5 Two X32 consoles with X-DANTE
connection to DVS for recording
64 simultaneous tracks
• •
Both consoles need to have X-DANTE cards installed.
Connect one of the X-DANTE Ethernet ports on console A
with the card installed in console B.
• •
Connect the second port of console B, either directly with
the DAW-PC/Mac or via a network router to which the DAW
has access. This link will carry all 64 channels to and from
both consoles.
Behringer
Router
X32
(optional)
Console A
Behringer X32
Console B
Two X32 consoles with X-DANTE connection to DVS for recording 64 simultaneous tracks
Quick Start Guide
• •
Tip: The console's Ethernet remote control can be done over
the same network. For remote controlling console A in this
example, it is sufficient to use a short patch cable connecting
console A's Remote connector with the free port on X-DANTE.
Since both ports on X-DANTE of console B are occupied
already, you would need to patch a separate cable to the
network router.
• •
Open the Dante Virtual Soundcard driver control panel and
switch it ON.
• •
Run the Dante Controller application to configure the virtual
channel patch bay and route the channels between Dante
Virtual Soundcard and the consoles.
Laptop/DAW
13
Advertisement
