Techly I-CASE FP-4506G Assembly Manual

STEP 1
➉
Use the M5x10 self-tapping screws
➄ ➆
fix part (post) and (bottom).
M5*10 self-tapping
locking screw: 8 PCS
STEP 4
Use the M5x10 self-tapping screws
➁
lateral part of the rear panel with top plate
Use the same screws to fix the post
➂ ➆
plate and bottom .
locking screw: 2 PCS
STEP 7
Use the M5x10 self-tapping screws
➀
hanging board to the cabinet body, pay
attention that the screws must be installed from
the inside out.
➀
Hanging board
➁
Backboard
➂
Top plate
➃
Side panel
➄
Post
➅
Front door
➆
Bottom plate
➇
19" mounting rails
➈
Bottom frame support block
M5*10 self-tapping
locking screw: 1 PC
to laterally Repeat STEP 1 to fix the other post
➆
bottom .
➉
to fix the Use the M5x10 self-tapping screws
➂ ➁
. back panel
➄
with top and top part and right and left of the back panel.
M5*10 self-tapping
➉
to install Install the side panels
installing the lock as explained on the next page.
WITH REMOVABLE SIDE PANELS
Packing List
1 pc
1 pc
1 pc
2 pcs
4 pcs
1 pc
1 pc
2 pcs
2 pcs
M5*10 self-tapping
locking screw: 1 PC
STEP 2
➄
to the
M5*10 self-tapping
locking screw: 4 PCS
STEP 5
➉
to fix the
to the cabinet body, fix the bottom
STEP 8
➃
to the cabinet after
19" WALL MOUNT CABINET
ASSEMBLY GUIDE
Item list of accessories package
➉
M5X10 self-tapping screws 22 pcs
M6X12 screws&square nuts 12U& less than12U,
10SET; More than 12U, 20SET
Tip: Check the quantities of the items after open
package, ensure the quantities is right to improve
the assembly efficiency.
Attention:
This hole is up!
STEP 3
Use the M5x10 self-tapping screws
➁ ➆
(back panel) and (bottom) at the sides and
back, making sure that the holes for fixing to the
wall must must facing upwards positioned at the
top.
STEP 6
➈
Fix the plastic block on the horizontal bracket
at the position where the front rail will be fixed.
➇
Then fix the rail by fixing them in the upper
and lower brackets using the M5*10 screws
Attention: fix the screws from the outside
towards the inside of the cabinet.
STEP 9
➅
Install the front door after installing the lock
supplied separately.
M5*10 self-tapping
locking screw: 2 PCS
➉
to fix parts
M5*10 self-tapping
locking screw: 4 PCS
➉
.
The tapered
door latch is
stretched down
and then fitted
into the top
panel latch hole
EN