Minors should be accompanied by adults when operating. Failure to operate or maintain this product safely may result in personal injury. It is the owner’s responsibility to operate this product safely. FrSky and its distributors are not responsible for any and all personal injuries and/or property damage caused by use of this product.
Instruction Manual for FrSky "Edge Warrior" 1/18 RC Crawler Please read this manual carefully before use. We are not responsible for any deliberate damage or improper use. This product is not a toy! It is recommended for ages 14 and up.
The system adopts a 2.4GHz dedicated RF protocol for ground remote control devices, supporting signal control and telemetry bidirectional data transmission. It can be used with many FrSky ground receivers. The receiver included with this product supports 4 channels of control signal output, 6 channels of LED light control signal, and a single motor control port.
Page 8
Instruction Manual for FrSky "Edge Warrior" 1/18 RC Crawler Receiver Overview [1] Reserved Port [8] Battery Port [9] Motor Port [2] Top Spotlights [10] Power Switch/Binding [3] Brake Taillights [11] LED Signal Indicator [4] Right Turn Signal [12] Antenna [10]...
Page 9
Instruction Manual for FrSky "Edge Warrior" 1/18 RC Crawler Pistol Grip Battery Installation & Low Voltage Alerts Battery Type: 4x AAA batteries Battery Installation: Please follow the battery installation guide, insert left 2 batteries with positive pole facing inwards and right 2 batteries with positive pole facing outwards.
Page 10
Instruction Manual for FrSky "Edge Warrior" 1/18 RC Crawler Calibrate Throttle and Steering Channels 1. Ensure receiver and pistol grip are in normal communication state. 2. Enter [Check] mode of [Device] on pistol grip. 3. Push throttle trigger fully forward and hold for 1s, then fully back and hold for 1s to record channel range.
Page 11
Instruction Manual for FrSky "Edge Warrior" 1/18 RC Crawler Pistol Grip Inactivity Alerts • If no operation for >20s, LCD backlight automatically turns off. • If no operation for >20min, pistol grip automatically powers off. Main Menu Introduction [1] Power Output Mode...
Page 12
Instruction Manual for FrSky "Edge Warrior" 1/18 RC Crawler NORMAL Forward Reverse Reverse Forward Th & Brake Normal Rate Brake output percentage, default 100% ESC Setting ESC Setting FOR-BR-REV: Forward-Brake-Reverse (NORMAL Mode) ESC Mode For-Br-Rev FOR-REV: Direct Forward-Reverse (CRAW Mode) Bat Protection 6.5V...
Page 13
Instruction Manual for FrSky "Edge Warrior" 1/18 RC Crawler Receiver Setting Switchable model with 5 sets of different Receiver parameters The set parameters will be automatically saved to the corresponding model number. Receiver [Bind] Failsafe ON Receiver Binding After the pistol grip is powered on, double...
Page 14
Instruction Manual for FrSky "Edge Warrior" 1/18 RC Crawler - 3: Following prompt instructions, turn steering all the way left to limit and hold 2 seconds, release wheel. When stationary, turn all the way right to limit and hold 2 seconds, release wheel. Pull throttle trigger all the way back to limit, hold 2 seconds, release trigger.
Page 16
Instruction Manual for FrSky "Edge Warrior" 1/18 RC Crawler Model Crawler Settings Battery Connect Step 1: Remove the model shell Step 2: Place battery in battery compartment Step 3: Connect battery plug Note: 1. Unplug batteries for long term storage to prevent damage.
Page 17
Instruction Manual for FrSky "Edge Warrior" 1/18 RC Crawler • Do not replace or modify battery pack connectors or wires. • Check the battery condition before charging or any other operation. • Do not short circuit batteries. • Do not directly touch leaked or damaged batteries.
Need help?
Do you have a question about the Edge Warrior and is the answer not in the manual?
Questions and answers