TDRFORCE DS-800S/2P Operating Instructions Manual

Jewelry steam cleaner

Advertisement

DS-800S/2P
Jewelry Steam Cleaner
Operating Instruction

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DS-800S/2P and is the answer not in the manual?

Questions and answers

Bruce Morriso
January 27, 2025

DS-800S/2P jewelry steam cleaner: Where are the assembly and setup instructions?

1 comments:
Mr. Anderson
May 14, 2025

You can find the assembly and setup instructions for the TDRFORCE DS-800S/2P jewelry steam cleaner in the Operating Instruction manual provided by TDRFORCE.

This answer is automatically generated

Summary of Contents for TDRFORCE DS-800S/2P

  • Page 1 DS-800S/2P Jewelry Steam Cleaner Operating Instruction...
  • Page 2: Technical Specification

    Power:1200W Steam Pressure: 2-5 bar Volume: Boiler 2L Material:Superior SUS 304 Highest Temperature in Steam Outlet: 135℃ Packing List A. DS-800S/2P Steam Cleaner B. Power Line C. Breaker D. Funnel E. Pedal Switch F. Activity Spray Gun G. Fixed Nozzle H.
  • Page 3 Notice 1.Check whether the power voltage is the same as the voltage of the cleaner prior to use. 2.Use clear water or mineral water and don’t use impure water as to avoid blocking pipe. 3.Don’t put the hand directly under the nozzle port during use so as to avoid scalding. 4.Keep the external surface of the cleaner clean and dry.
  • Page 4: Operating Method

    Application -Cleaning of high quality is the premise for quality assurance of electroplate on the jewelry surface. DS series steam cleaner is especially suitable for cleaning all kinds of ornaments with complicated design. Ornaments cleaned by steam will better guarantee the adhesion and brightness of electroplate when plated. -DS series steam cleaner can generate steam of high pressure to ensure the touch between the steam and each angle of inlaid products.
  • Page 5 when the pressure arrived the set pressure value, the heating indicator show the green light. 4. When the boiler water level is full of water, the full water indicator “F” lights up and alarms 1 sec. 5. When the machine is short of water during use, the heating automatically stops, the shortage water indicator “L”...
  • Page 6: Troubleshooting

    Trouble Shooting TYPE OF DEFECT CAUSE SOLUTION -Water line or the nozzle No steam comes out from -Use pure distilled water is blocked. the nozzle. as the water supply. Use a needle to unclog the nozzle. -Blocked heating tube. -Replace the boiler. Use pure distilled water as the water supply.
  • Page 7 Machine buzzing when -The steam in the boiler -Press the safety valve on turned on. has condensed without the top or step on the releasing pressure, which pedal to release negative leads to negative pressure pressure. and buzzing in the machine.
  • Page 8 Customer contact, please keep it properly. Dear customer: Thank you for choosing products of TDRFORCE. In order to provide you with more satisfactory service and better protect your rights, please read this regulation carefully and keep the warranty card properly.

Table of Contents