Advertisement
Table of Contents
- 1 Battery Tray Parts
- 2 Step 1: Place Two 3.375” Churros between the Bottom Plate and the C Plate
- 3 Step 2: Slide the Assembly over the End Plate
- 4 Step 4: Attach the Clamp to the End Plate Using Two 10-32X1.5” SHCS, Nuts, and Spacers
- 5 Step 5: Secure the Robot Side SB-Series Battery Connector to the Tab on the C Plate
- 6 Step 6: Feed the Battery Strap through the Top of the Slot, Loop Around and through the Buckle
- 7 Step 8: Plug the SB Connector from the Battery into the SB Connector Mounted to the Tray
- Download this manual
Battery Tray Parts
Component
10-32 x 0.5 SHCS
10-32 x 1.5 SHCS
1/4-20 x 0.75" Thread
Rolling Screw
10-32 Nylock Jam Nut
6-32 x 0.750 HHS
6-32 Nylock Jam Nut
500 Churro, 3.375"
Battery Strap
#10 Spacer
Battery Bottom Plate
Battery C-Plate
Battery Clamp
Step 1: Place two 3.375" Churros (am-2569) between
the Bottom Plate (am-3959) and the C Plate (am-
3958). Secure the Churros to the plate with four ¼-20
x 0.750" Thread Forming Screws (am-1310). Make
sure the tabs on both plates are pointing upwards.
AM14U Battery Mount Installation – am-3964a
Robotics is a high-contact sport. It's important to keep your battery protected and
secured during the match. AndyMark recommends using this vertical mount to
securely hold the battery and conveniently mount your robot power connector.
Part Number
am-1002
am-1014
am-1310
am-1063
am-1564
am-1419
am-2569
am-3965a
am-3876
am-3959
am-3958
am-3960
QTY
8
2
4
10
2
2
2
1
2
1
1
1
Step 2: Slide the assembly over the End Plate. The C Plate
and Bottom Plate should be installed on the top and
bottom of the flanges on the End Plate, respectively.
Note: The assembly may need to be slightly flexed to fit
over the flanges on the End Plate.
Part Photo
October 2023
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for AndyMark AM14U
Summary of Contents for AndyMark AM14U
- Page 1 AM14U Battery Mount Installation – am-3964a Robotics is a high-contact sport. It’s important to keep your battery protected and secured during the match. AndyMark recommends using this vertical mount to securely hold the battery and conveniently mount your robot power connector.
- Page 2 Step 3: Secure the assembly to the End Plate using Step 4: Attach the clamp to the end plate using two 10- eight #10-32 x 0.500” SHCS and #10-32 Nylock Jam 32x1.5”SHCS, nuts, and spacers. The clamp should be Nuts. centered with the assembly.
Need help?
Do you have a question about the AM14U and is the answer not in the manual?
Questions and answers