Advertisement
NOTE: Children from age 8 years and above, persons with reduced physical, sensory, or mental capabilities those with lack of
experience and knowledge can use the appliance, if they have been given supervision or instruction concerning use of the appliance
in a safe way to understand the hazards involved.
Children shall NOT play with the appliance.
9
Cleaning and user maintenance on the appliance shall not be made by children without supervision. That the appliance shall be
9
disconnected from its power source during service and when replacing parts and, if that the removal of the plug is foreseen,
it shall be clearly indicated that the removal of the plug has to be such that an operator can check from any of the points to which
he has access that the plug remains removed.
During charging, the battery must be placed in a well-ventilated area.
9
The battery charger must only be plugged into an earthed socket-outlet.
9
The battery terminal not connected to the chassis has to be connected first. The other connection is to be made to the chassis, remote
9
from the battery and fuel line. The battery charger is then to be connected to the mains supply.
The battery terminal not connected to the chassis has to be connected first. The other connection is to be made to the chassis, remote
9
from the battery and fuel line. The battery charger is then to be connected to the supply mains
Examine the battery charger regularly for damage, especially the cord, plug and enclosure. If the battery charger is damaged, it
9
must not be used until it has been repaired by the manufacturer, its service agent or similarly qualified persons in order to
avoid a hazard.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to
9
avoid a hazard.
1.3.
PERSONAL PRECAUTIONS
Ensure there is another person within hearing range of your voice and close enough to come to your aid, should a problem arise when
9
working near a lead-acid battery.
Wear safety eye protection and protective clothing. Avoid touching eyes while working near battery.
9
Have fresh water and soap nearby in case battery acid contacts skin, clothing or eyes.
9
Wash immediately with soap and water if battery acid contacts skin or clothing. If acid enters eye, flush eye immediately with cool, clean
9
running water for at least 15 minutes and seek immediate medical attention.
Remove personal metallic items such as rings, bracelets, necklaces and watches. A lead-acid battery can produce a short-circuit current
9
which is high enough to weld a ring or the like to metal, which would cause severe burns.
Ensure hands, clothing (especially belts) are clear of fan blades and other moving or hot parts of engine, remove ties and contain long hair.
9
DO NOT smoke or allow a spark or flame in the vicinity of battery or engine.
8
1.4.
CHARGING SAFETY INSTRUCTIONS
Familiarise yourself with the application and limitations of the charger as well as the potential hazards. Also refer to the vehicle
9
manufacturer's hand book. IF IN ANY DOUBT CONSULT A QUALIFIED ELECTRICIAN.
Ensure the charger is in good order and condition before use. If in any doubt do not use the unit, contact your Sealey stockist.
9
Use the starter/charger in the upright position only and ensure it is placed on a stable surface which will adequately support its weight.
9
Ensure the charger is disconnected from the mains supply before attaching/detaching the power clamps to/from the battery.
9
Keep tools and other items away from the engine and ensure you can see the battery and working parts of engine clearly.
9
Ensure the output of the charger is the same voltage as the battery.
9
Ensure that during charging, the charger is placed in a location where there is sufficient ventilation to prevent the build up of explosive
9
gases from a lead acid battery, and DO NOT cover or obstruct the charger ventilation louvres.
If battery has caps to access the battery fluid, remove the caps and check the fluid level before connecting the power clamps.
9
If necessary top-up the battery with distilled water by referring to the battery manufacturer's instructions (Apply the personal safety
9
precautions described in part 1.3).
9
If the charger receives a sharp knock or blow the unit must be checked by a qualified service agent before using.
9
If the battery terminals are corroded or dirty clean them before attaching the power clamps.
9
Keep children and unauthorised persons away from the working area.
9
When not in use, store the charger carefully in a safe, dry, childproof location.
9
Ensure there is effective ventilation to prevent a build-up of explosive gases, and DO NOT cover or obstruct charger ventilation louvres.
9
WARNING! If a fuse blows, ensure it is replaced with an identical fuse type and rating. Use only Sealey genuine parts.
‰
WARNING! To prevent the risk of sparking, short circuit and possible explosion DO NOT drop metal tools in the battery area, or allow
‰
them to touch the battery terminals.
WARNING! DO NOT simultaneously charge batteries of different capacities or discharge levels.
‰
DO NOT dis-assemble the charger for any reason. The charger must only be checked by qualified service personnel.
8
DO NOT try to charge a non-rechargeable battery.
8
DO NOT try to charge battery if battery fluid is frozen.
8
DO NOT allow power clamps to touch each other or to make contact with any metallic part of the vehicle.
8
DO NOT cross connect power leads from charger to battery. Ensure positive (+/RED) is to positive and negative (-/BLACK) is to negative.
8
DO NOT pull the cables or clamps from the battery terminals.
8
DO NOT use the charger outdoors, or in damp, or wet locations and DO NOT operate within the vicinity of flammable liquids or gases.
8
DO NOT use charger inside vehicle or inside engine compartment.
8
DO NOT use the charger for a task for which it is not designed.
8
2. INTRODUCTION
Combination units with two charge settings and a start function to jumpstart vehicles with a flat battery. Features easy-to-read ammeter and
illuminated power switch. Dual output (12 and 24V) and circuitry is protected by a panel mounted fuse. Suitable for garages, workshops and fleet
operators running cars and van derivatives. Built-in polarity protection.
3.
SPECIFICATION
i
MODEL NO.
Cable and Clamp Length
Fuse Rating
Plug Type
© Jack Sealey Limited
SUPERBOOST180.V6
2m
N/A
Bare Wire
Original Language Version
SUPERBOOST200.V5
2m
N/A
Bare Wire
SUPERBOOST SERIES: 180.V6, 200.V5
Issue 1
27/06/23
Advertisement
