Adjustment During Playback - Mitsubishi HS-7424E Installation And Operation Manual

ADJUSTMENT DURING PLAYBACK
z +:
If noise appears.
POSITION/ POSITION/
TRACKING VERTICAL TR VERTICAL
ADJUST ADJUST
op
even though adjusted with tracking button.
* The noise bars will move continuously when a TRACKING button is depressed except in L12H or L24H playback mode.
¢ The noise bars will move every time when a TRACKING button is pressed every time in L12H or L24H playback mode.
SOFT PICTURE SHARP
SOFT SHARP
NOTE:
¢ This control is only effective during playback.
When watching still, slow motion, fast playback or normal playback in L12H or L24H mode, the picture may vibrate. In
this case, press the VERTICAL ADJUST(+) or (-) button to reduce or eliminate the picture vibration.
When the picture is
POSITION/
ibrati PO
vibrating
TRACKING VERTICAL
TRACKING VR
ADJUST ADJUS
= ae
ADJUST" for 3H respectively by the following procedures.
[1] Record image and still-playback the tape.
[2] Press the VERTICAL ADJUST (+) or (-) button to reduce or eliminate the picture vibration.
NOTE:
¢ Horizontal vibration cannot be corrected with the VERTICAL ADJUST buttons.
e When the VERTICAL ADJUST (+) and (-) buttons are Bier at the same time during still playback, the
VERTICAL ADJUST is set to initial setting.
23