Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for UEi IRP-2
Summary of Contents for UEi IRP-2
- Page 1 IRP-2 Infrared Printer Infrared Printer...
-
Page 2: Operating The Printer
The IRP-2 is a portable printer using thermal paper that links to other UEi products using an infrared link. It incorporates an ‘easy load’ paper facility and allows NiMh batteries to The IRP-2 is a portable printer using thermal paper that links to other... -
Page 3: Additional Information
Undefined (Vertical) ADDITIONAL INFORMATION SELF TEST Power off the IRP-2, hold down the PAPER FEED key and press POWER ON/OFF key, the output will be all the letters including the Latin format PRINT CONTRAST The contrast of the IRP-2 output can be adjusted both lighter and darker by pressing the... -
Page 4: Replacing The Paper Roll
REPLACING THE PAPER ROLL REPLACING THE PAPER ROLL To replace the paper roll in the IRP-2, release the paper cover by pressing down the To replace the paper roll in the IRP-2, release the paper cover by pressing down the To replace the paper roll in the IRP-2, release the paper cover by pressing down the release lever. -
Page 5: Status Indicator
HEAD THERMAL LIMIT HEAD THERMAL LIMIT In the event of extensive printing periods the temperature of the thermal head of the IRP-2 may rise to an unusable level, if this occurs the STATUS INDICATOR will flash twice and In the event of extensive printing periods the temperature of the thermal head of the IRP-2 may rise to an unusable level, if this occurs the STATUS INDICATOR will flash twice printing will be suspended until the temperature falls to an acceptable level. -
Page 6: Environmental Limits
(this can either be due to the distance or the angle of operation), obstruction of the infrared signal or even interference from another infrared emitting source. ENVIRONMENTAL LIMITS The IRP-2 is designed for indoor use only. Operating temperature: 32°F to 104°F (0°C to 40°C) Storage temperature: -4°F to 140°F (-20°C to 60°C) -
Page 7: End Of Life Product Disposal
CLEANING The outer case and protective boot (if applicable) can be cleaned using a damp cloth and non abrasive detergent. After cleaning leave the product in a warm dry place until the surfaces are completely dry. Under no circumstance use solvent or hydrocarbon based products as they can cause serious damage to plastic and rubber. -
Page 8: Electromagnetic Compatibility
At the time of writing this manual (May 2016) UEi Test Instruments is not aware of any field based situation where such interference has occurred and this advice is only given to satisfy the requirements of the Directive.
Need help?
Do you have a question about the IRP-2 and is the answer not in the manual?
Questions and answers