Table of Contents
Advertisement
INDEX
Safe Operation Practices.2
Assembly.3
4
Installing the Battery.5
Lubrication. 10
11
Belt Replacement.13
Transaxle. ^
Repair Parts. 18
Wiring Diagram.26
Parts Information.Back Cover
IMPORTANT
After striking a foreign object, stop the
engine. Remove wire from spark plug,
thoroughly inspect the mower for any
damage, and repair the damage be¬
fore
restarting
and
operating
the
mower.
The steering wheel and seat, with the necessary hard¬
ware, are easily assembled to the machine. The battery
must be activated and installed as outlined in this sec¬
tion.
TIRE PRESSURE
r'T--V\
V-4
Hex Nut Vi-13 Thd.
D
Spring Lockwasher
'/a" Screw
F
(ED
Hex Lock Nut 5/16-18Thd.
FOR SHIPPING PURPOSES, THE TIRES ON YOUR UNIT
MAY BE OVER-INFLATED. TIRE PRESSURE SHOULD BE
REDUCED BEFORE UNIT IS PUT INTO OPERATION.
PRESSURE
SHOULD
BE
APPROXIMATELY
15
P.S.I.
EQUAL TIRE PRESSURE SHOULD BE MAINTAINED ON
ALL TIRES. MAXIMUM TIRE PRESSURE IS 30 P.S.I.
CAUTION
Installation of tire to rim:
1. Lubricate
tire
beads
and
rim
flanges.
2. Do not exceed 30 P.S.I. when seat¬
ing beads.
3. Adjust to recommended pressure
after beads are sealed.
Belleville Washer
G
Wing Nut Vi-20
H
o
Lockwasher
Hex Nut
Vi " Screw
Vi-20 Thd.
FIGURE 1. HARDWARE SUPPLIED
rrn
Hex Bolt
Vi-20 x 5/8
ASSEMBLY
Step 1. Remove the lawn mower and all parts from
the carton. Make certain that all loose parts
and literature have been removed before the
carton is discarded.
Reference to right-hand or left-hand
side of machine is from the driver's
seat facing forward.
Step 2. Place steering wheel over steering shaft.
Step 3. Secure with Belleville Washer (E) and Hex Nut
(F). See figure 2.
Step 4. Press the cap on the steering wheel by hand.
See figure 2.
3
Advertisement
Table of Contents
