Table of Contents
Advertisement
wires, solder, and tools, which you must provide. Figure
4.-1 shows how an assembled connector is installed on the
front of the Digital I/O.
NOTE
An optional Terminal Block (HP 14802A) is available that allows
you to connect wires to the Digital I/O using the screw
terminals it provides (see Appendix D).
Figure 4*1. Application Connections
Assembling the
Connector
Refer to Figure 4-2 and assemble the connectors that are
shipped with your instrument as follows:
CAUTION
To prevent shorted connections when assembling your input and
output connectors, do not strip wires back more than 0.15 in
(4 mm). Use only AWG 20 (0.5 mm2) wire guage. Only use the
form and type of connector originally supplied with the
equipment.
4-2
Front Panel Connections
Advertisement
Table of Contents
