Table of Contents
Advertisement
6-2.
Fuse Replacement
The fuse may be blown if the pilot lamp
and illumination lamp do not go ON when
the main switch is turned ON. Before start¬
ing replacement, be sure to turn OFF the
main
switch and disconnect
the power
cord from the wall outlet.
To replace the fuse, first use a single¬
blade screwdriver or the like and release
the click-locks on the sides of the fuse
box in the rear of the main body, as
shown in Fig. 6-4.
Then remove the box
together with the fuse. After replacement
with a new fuse, match the notch direc¬
tion and push in the fuse box firmly till it
clicks.
Use two fuses of 1
A/250 V
(short).
Fig. 6-5
6-3.
Remote Controller Battery Replacement
Perform steps 1 through 3 as follows.
• The dry cell may need replacing if the chart does not move or if it moves slowly when
one key of the remote controller was pressed.
Replace with two AA batteries available in any store. Use of alkaline dry batteries is re¬
commended to ensure long life.
1 Push the stop spring with your fingertip
to remove the cell cover in the rear of
remote controller, as shown in Fig. 6-6.
2 Insert the cells according to the [+]
and [-] marks in the battery chamber
of the remote controller.
3 Fit the cover as before.
Battery cover
\
18
Advertisement
Table of Contents
