Summary of Contents for IKIER R2
- Page 1 English R2 Roller Installation Manual Note: The picture is for reference only, subject to the real thing. F03-0136-0AA1 Please scan the two-dimensional code for more information. Versions：A...
-
Page 2: Packing List
Packing List Roller body*1Pcs Bracket*1Pcs Sequence line*1Pcs Reverse sequence line*1Pcs... - Page 3 Installation Guide Step 1: Roller Motor Roller block Roller Roller block Base...
- Page 4 Installation Guide Step 2: Choose different gears to install according to the engraved items Gear 1： 10mm≤ d ≤20mm Gear 2： 30mm≤ d ≤40mm Gear 3： 40mm≤ d ≤50mm Gear 4：50mm≤ d ≤80mm...
- Page 5 Installation Guide Step 3: Adjust Gear 3.1 Select different gears according to the engraved items. 3.2 Move the roller to the appropriate gear and tighten the screw. 3.4 Adjust the bracket installation: choose different gears according to the 3.3 Move the motor to tighten the belt and tighten the screws at engraved special-shaped items, and move the bracket to a suitable position.
- Page 6 The 4PIN black plug wire is used to connect the third-party laser engraving machine. The roller kit supports IKIER and third-party laser cutters and engravers. You need to connect it to the device and use the corresponding software to operate it. If it cannot be connected, please change the order of the wires, and the change process is shown in Figure 1.1-1.2.
- Page 7 Use LightBurn 1. Add "Enable Rotary" to main window 1.1 Click "Settings" on the toolbar 1.2 In the settings window, turn on the "Show rotary enable on main window" button, and click OK. Show rotary enable on main window Enable Rotary...
- Page 8 Use LightBurn 2. Open the Rotary Setup window and set the parameters 2.1 Open the Rotary Setup window: Click "Laser Tools" on the toolbar and then click "Rotary Setup" Rotary Setup 2.2 Set the correct parameters in the Rotary Setup window: As shown in the figure Steps: (1) Select the rotary type: Roller Type (2) Turn on "Enable Rotary"...
- Page 9 Use LightBurn 3. Import the pattern you want to engrave, set the size of the pattern, and set the engraving power and speed. 4. You can click "Frame" to preview the position of the pattern to be engraved, and then move the laser head to the expected position.
-
Page 10: Customer Service
Customer service: For detailed warranty policy, please visit our official website: www.ikier.com For technical support and service, please email support@ikier.com Manufacturer: Shenzhen ikier Technologies Co.,Ltd Address: 422, Building 1, Xili Mingliang Science and Technology Park, No.178 Zhuguang North Road, Nanshan District, Shenzhen, Guangdong, China...