Advertisement
Available languages
Available languages
Warning Statements
The wall structure must be capable of supporting at least a maximum
weight of 45kg (99lbs) for 32"-50" televisions. If not, the wall must be
Warning
reinforced. Proper installation procedure by a qualified service
technician, as outlined in the installation instructions, must be adhered
to. Failure to do so could result in serious personal injury, or even
death.
Safety measures must be practiced at all times during the installation
Warning
of this product. Use proper safety gear and tools for the installation
procedure to prevent personal injury.
Prior to the installation of this product, the installation instructions
should be read and completely understood. The installation
Warning
instructions must be read to prevent personal injury and property
damage. Keep these installation instructions in an easily accessible
location for future reference.
A secure structure must support the weight or load of the display,
When mounting to a wall that contains wooden studs, dead center of
the wooden stud must be confirmed prior to installation.
Do not install on a structure that is prone to vibration, movement or
chance of impact. Failure to do so could result in damage to the
display and/or damage to the mounting surface.
Do not install near heater, fireplace, direct sunlight, air conditioning or
any other source of direct heat energy. Failure to do so may result in
damage to the display and could increase the risk of fire.
At least two qualified people should perform the installation procedure.
Injury and/or damage can result from dropping or mishandling the
display.
Recommended mounting surfaces: wooden studs and solid-flat
concrete. If the mount is to be installed on any surface other than
wooden studs, use suitable hardware (which is commercially
available).
Hardware kit:
(x4) M4x12 Bolt
Bag
(x4) M4x30 Bolt
1
(x4)
M4
Washer
(x4) M5x12 Bolt
Bag
(x4) M5x30 Bolt
2
(x4)
M5
Lock
Washer
(x4) M6x12
Bag
Bolt
3
(x4) M6x35 Bolt
(x4)
M6
Lock
Washer
© by WilTec Wildanger Technik GmbH
http://www.wiltec.info
Bag
Lock
4
Bag
5
Bag
6
(x4) M8x16 Bolt
(x4) M8x40 Bolt
(x4)
M8
Lock
Washer
(x4) M4/M5 Spacer
(x4) M6/M8 Spacer
(x4) M4/M 5 Washer
(x1) Bubble Level
(x6) M8x60 Lag Bolt
(x6) Washer
(x6) Concret
System
anchor
Seite 7
Advertisement
