Table of Contents
Advertisement
The RC22M Roping Chute can attach to almost any steer alley or panel configuration with standard
chain connections. Lubricate all working parts including tailgate before operating the RC.
Use WD-40 or other light lubricant. Heavier oil collects dust and restricts proper operation.
Frequent lubrication will be necessary until excess paint is worn off working parts.
Note: Be aware of specific locations that should not be lubricated.
These locations are noted with decals stating DO NOT OIL. (Noted on Previous Page)
All of the RC22M controls are accessible from Header or Healer side.
Familiarize yourself with their operation using the illustrations provided below.
Tailgate Handles
Pull Handle to open Tailgate and
allow steer to enter chute.
Push Handle to close Tailgate.
Front Gate Brake
The urethane brake system on top front of chute
& springs on each side of the chute are pre-
adjusted at the factory and should not need to be
adjusted until chute has considerable use on it.
Now Available with the RC22AI, RC22Q39, &
RC22SCORE
The RC22 Chutes now work, not only Automatically, but, Manually as
well. This means if an RC22M Manual Chute was initially purchased,
it can be upgraded to a Q39 or an Automatic chute. An RC22AI or
Q39 can be operated manually if power is not available.
In addition, the RC22SCORE can also be operated manually if
power is not available.
Contact Customer Service at 1-800-527-8616 for any questions
about upgrading.
02
Manual Roping Chute
Operating Instructions (RC22M)
Roping Chute Hook-Up
Roping Chute Operation
Front Gate Release Handles
Push Handle down to open spring-
loaded front gate and release steer.
Resets automatically.
Front Gate Close Handles
Pull Handle back to close spring-
loaded front gate and reset for
next release.
OPMAN-RC22AI_v1a-0523
RC22AI
Advertisement
Table of Contents
