Cres Cor CSH-122-10 Series Operating And Maintenance Instructions

5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
Model: CSH-122-10 Series, 120 and 240 Volt
ELECTRICAL SPECIFICATIONS:
Model No.
CSH-122-10
CSH-122-10
THERMOSTAT KNOB
HOW TO OPERATE UNIT:
1. Plug cord into proper wall outlet.
2. Push thermostat switch
to no. 10.
3. Preheat for 30 minutes; then add cutting board
and/or pans to the heated base.
4. Push lamp switch(es) to
heat.
NOTE: Proper food holding temperature is 140°F
(60°C) or higher.
For uncovered pans or product:
Leave thermostat on no. 10 setting.
For covered pans or product:
Turn the thermostat to no. 6 setting.
5. Push switches and turn thermostat "OFF" when
done.
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
Volts Watts
120 1100
240 1150
OFF
0595-002
"ON" and turn thermostat
"ON" for additional
Amps Hertz
9.2 60
4.8 60
THERMOSTAT BEZEL
0848-063
HEATERS "ON/OFF"
CLEANING INSTRUCTIONS:
1. Remove power cord from wall outlet.
2. DO NOT immerse unit in water.
3. DO NOT get water on controls.
4. Wipe cooled exterior with soap and water.
5. DO NOT use abrasives or harsh
chemicals.
REPLACEMENT PARTS:
Lamp, Red (250 Watts) ................................ 0820-001
Lamp, White (250 Watts) ............................. 0820-033
Lamp, Red (275 Watts/240 Volts) ................ 0820-014
Cutting Board ............................................... 1004-018
Legs - Adjustable ......................................... 1206-027
Socket ........................................................... 0822-037
Carving
Station
Page 1 of 2
Rev. 7 (4/08)
Phase NEMA
1 5-15
1 6-15
HOOD "ON/OFF"
FL-2206
Service
15 AMP
15 AMP