Table of Contents
Advertisement
en Fault, what to do?
Fault
A different error code is
indicated on the digital
display.
(":‹‚ to ":„‹)
Refill indicator for rinse-aid
H is lit.
Refill indicator for rinse-aid
H is not lit.
Water is left in the
appliance at the end of the
programme.
Utensils not dry.
Plastic utensils not dry.
36
Cause
A technical fault has probably
occurred.
No rinse aid.
Refill indicator switched off.
There is still enough rinse aid
available.
Filter system or area under the
filters 1b is blocked.
Program has not ended yet.
No or too little rinse aid in the
dispenser.
Programme selected without
drying.
Water collecting in depressions
on the utensils and cutlery.
The combined detergent used
has a poor drying performance
ExtraDry to increase drying not
activated.
Utensils were removed too early
or drying process had not ended
yet.
The eco rinse aid used has a
limited drying performance.
Special properties of plastic.
Remedial action
Switch off appliances with the ON/OFF
switch (. After a short time restart the
appliance.
If the problem recurs, turn off the tap and
pull out the mains plug.
Call customer service and mention the
error code.
Refill rinse aid.
Activation/deactivation.~ "Rinse aid"
on page 15
Check refill indicator, levels.
Clean filters and area underneath.
Wait until programme ends or reset.
Refill rinse aid.
Select programme with drying.
Arrange utensils in a sloping position,
arrange affected utensils as sloping as
possible.
Use different combination detergent with
better drying performance. Use of rinse
aid also increases the drying performance.
Activate ExtraDry.
Wait until program ends or wait until 30
min after program ends before removing
utensils.
Use a proprietary rinse aid. Eco products
may have limited effectiveness.
Plastic has a lower heat storage capacity
and therefore dries less well.
Advertisement
Table of Contents
