Toshiba 37XV566D Manual page 8

ADJUSTMENT [LCD Color Television] ASIA_EU
CAUTION: Never attempt to initialize the data unless IC510 has been
replaced.
Whenever using new signal board to the set, set the Model ID data
according to Panel option data.
1) Enter the service mode.
2) Select menu of ID by pressing P
service mode.
3) Change ID data into MODEL ID to initialize by pressing
below.
4) Press and hold the CALL button on the remote control, then press the PROGRAMME
button on the TV.
5) Initialization progress dialog including model name and panel vendor is shown.
Progress status is "WRITING".
6) Progress status is changed "OK" and power cycle (automatically). Then IC510
initialization has been completed.
7) Enter the service mode and select version check mode. Confirm if model name and
model id set is correct. If not, repeat steps 1) to 6).
Note:
In case initialization by setting wrong MODEL ID is done, there is a possibility of
abnormal display.
8) Set I2C check function of TVOP to enable.
9) Check the picture carefully. If necessary, adjust any adjustment item above.
Perform "Auto tune" on the owner's manual.
MODEL ID (HEX) Model name Panel vendor
0x19 37XV566D
file://C:\Documents and Settings\Alexsandr\Local Settings\Temp\Rar$EXa0.221\37X...
or P during display of adjustment menu in the
LGD
Стр. 8 из 16
+ or -, refer to table
12.05.2015