Advertisement
Advertisement
Table of Contents
Summary of Contents for Zenitel ZMK-1
- Page 1 Zenitel Multipurpose Kit ZMK-1 Mounting & Installation Manual A100K12170 v1.4...
-
Page 2: Safety Information
ZMK-1 Zenitel Multipurpose Kit - 1 Safety information This manual describes the necessary steps to install the ZMK-1. It contains important instructions that must be followed. ZMK-1 must be installed by a trained technician in accordance with national and local regulations. - Page 3 2 I/O connection options . Typically used as digital I/O interface input (eg. from a closing contact) or digital output (12mA). The ZMK-1 has a built-in relay of which a NO contact is Relay available on the connector strip. This can power up to 440W.
- Page 4 Mounting The ZMK-1 can be mounted on any flat surface, either horizontally or vertically. NB! The ZMK-1 has an IP20 rating, please make sure the unit is mounted in a dry environment. All dimensions in mm 36,5 Ø 5,2 2x Pan Head Screws, M4/M5, head diameter >10mm...
-
Page 5: Installation
Installation Connect ZMK-1 to the touch screen by connecting a USB-C cable to the USB port number 3 and an HDMI cable to the HDMI port, then connect the cables to the touch screen. Connect ZMK-1 to a power source/network. Connect an Ethernet cable to either Eth 1 port or Eth 2 port, then connect a PoE+ Switch/Injector. - Page 6 Connectors The ZMK-1 provides a whole range of different usage and connection possibilities. The set of connectors enables tailor-made solutions suited to most needs. Connect the various components as shown in this figure.
- Page 7 PoE+ Switch Get the IP address. When the ZMK-1 is connected to the network, the IP address of the device is automatically assigned in one of two ways: An IP address is automatically obtained from a DHCP server if a DHCP server is present on the network.
-
Page 8: Contact Information
Contact Information Visit zenitel.com to find your country’s contact information. Specifications Technical specifications Value Weight 320g Dimensions (HxWxD) 36.5 x 154 x 71.5mm IP Rating IP20 IK Rating IK08 Relative humidity < 95% not condensing Operating temperature -40° to 70° C / -40° to range 158 °... - Page 9 The WEEE Directive does not legislate that Zenitel, as a ‘producer’, shall collect ‘end of life’ WEEE. This ‘end of life’ WEEE should be recycled appropriately by the owner who should use proper treatment and recycling measures. It should not be disposed to landfill.
- Page 10 Zenitel and its subsidiaries assume no responsibility for any errors that may appear in this publication, or for damages arising from the information therein. Zenitel, Vingtor-Stentofon and Phontech products are developed and marketed by Zenitel. The company’ s Quality Assurance System is certified to meet the requirements in NS-EN ISO 9001.