Sabbath Mode; Alarm; Door Alarm - Bosch KUL22 Series Information For Use

en Alarm
In order to utilise the freezing capa-
city, use the Super function.
→ "Freezing capacity", Page 19
Note: When the Super function is
switched on, increased noise may
occur.
Switching on Super function
Press repeatedly until "super"
▶
lights up.
Note: After approx. 24 hours, the ap-
pliance switches to normal operation.
Switching off Super function
Press repeatedly until the tem-
▶
perature display shows the re-
quired temperature.
8.2 Sabbath mode
To ensure that you can also use the
appliance on the Sabbath, the Sab-
bath mode switches off all non-es-
sential functions.
During Sabbath mode, the following
functions are switched off:
¡ Alarm
¡ Interior lighting
¡ Audible signals
¡ Messages on the control panel
Note: The brightness of the control
panel lighting is reduced during the

Sabbath mode.

Switching on Sabbath mode
Press and hold
▶
until an audible signal sounds.
lights up.
a
Note: After approx. 80 hours, the ap-
pliance switches to normal operation.
Switching off Sabbath mode
Press and hold
▶
until an audible signal sounds.
1
Wi-Fi is a registered trademark of the Wi-Fi Alliance.
16
for 15 seconds
for 15 seconds

Alarm

9 Alarm
Alarm
9.1 Door alarm
If the appliance door is open for a
while, the door alarm switches on.
A warning tone sounds and
up.
After 10 minutes, the interior lighting
flashes.
Switching off the door alarm
Close the appliance door or press
▶
.
a The warning tone is switched off.
Home Connect
10 Home Connect
This appliance is network-capable.
Home Connect
Connect your appliance to a mobile
device to control its functions via the
Home Connect app.
The Home Connect services are not
available in every country. The avail-
ability of the Home Connect function
depends on the availability of
Home Connect services in your coun-
try. You can find information about
this at: www.home-connect.com.
To be able to use Home Connect,
you must first set up the connection
to the WLAN home network (Wi-Fi
and to the Home Connect app.
After switching on the appliance, wait
at least 2 minutes until internal
device initialisation is complete. Only
then should you set up Home Con-
nect.
The Home Connect app guides you
through the entire login process. Fol-
low the instructions in the Home Con-
nect app to configure the settings.
lights
1
)