Panasonic SC-EN27 Operating Instructions Manual page 4

Radio s tations can betuned m anually by selecting the station's frequency orthey c an bepreset into channels tomake i teasy t otune.
You can preset up to20FM channels and up toI2AM channels.
i._/- -/=e-i
c::::_ 1
To adjust the volume
- VOLUME +
[c::::::_
,, ,-], ,::
/
o
(Minimum) (Maximum)
Each country allocates broadcast bands according to their particular system.
Input using the numbered
buttons
To select a 2-digit number
e.g. 11: [>10] _[1] * [1]
To adjust the volume
[SC-EN25/SC-EN26]
-_ ALBUM I_t,i pRESEt TUNE
Q@ @@
You can change the FM step. The step is factory-set to 0.2 MHz, but you
can change it to receive broadcasts allocated 0.1-MHz steps.
Any FM frequencies preset in channels will be changed by this procedure.
Preset them again.
1. Select the AM band with [TUNER/BAND].
2. Press and hold [TUNER/BAND] on the unit.
After a few seconds the display changes to show the current minimum
frequency. Continue to hold the button down. The minimum frequency
changes and the step is changed.
To return to the original step, repeat the above steps.
The preset memory will be initialized when you change the frequency step.
ecewe the radio stations after
]connecting the antenna. Then Change the direction and location
]attach the antenna code on the waft of the antenna.
]
t or pillar in the good reception. _,
if noise is excessive in F[v]
You can improve FM reception by switching reception to monaural.
PLAY
MODE
Press to turn the MONO
mode ON/OFF
1441-- "1"/_'1
Select "FM" or "AM"
Select the frequency
Select the frequency
Main unit I
TUNER/_ANO
Select "FM" or "AM"
Select "FM" or "AM"
ECCC3
Press and hold until the
frequency starts changing
rapidly
0@
Press and hold until the
frequency starts changing
rapidly
• Auto tuning stops when it finds a station.
• To cancel auto tuning press the same button again.
• Auto tuning may not function when there is
excessive interference.
Perform once for FM stations and once forAM stations.
PGNVCLEAR
-AUTO PRESET
Select "FM" or "AM" Press and hold until
"AUTO" appears
During automatic presetting, the memory indicator
(F2"a_) f lashes and the frequency scrolls. The memory
indicator and channel numbers are displayed for a
second when a station is preset.
The first station to be preset is displayed when
presetting finishes.
Tune to the
signal you
wantto
set as the
preset.
@@@
• •000
-AUTO PRESET
Enter preset mode @ @
Select a channel
The station occupying a channel is erased if another
station is preset over that channel.
Isc-EN25'SC-EN2el
_ALBUM_4 PRESETTUNE
Select "FM" or "AM" Select a channel
OO@
• 000
000
00
Select "FM" or "AM" Select a channel
J