Advertisement
Sponge Roller Cleaner
SRC-500DC
Operation Manual
Thank you for purchasing the SRC-500DC.
Read these instructions thoroughly for proper use of this device.
Make sure to read "Safety Notes" before you use the device.
This information protects you from possible dangers during use.
Apollo Seiko Ltd.
Rev.2.00
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Apollo SRC-500DC
- Page 1 Sponge Roller Cleaner SRC-500DC Operation Manual Thank you for purchasing the SRC-500DC. Read these instructions thoroughly for proper use of this device. Make sure to read "Safety Notes" before you use the device. This information protects you from possible dangers during use.
- Page 2 We do not take responsibility on a loss caused by a wrong connection with other equipment. If for any reason the internal circuitry is tampered with altered or repaired without written consent of Apollo Seiko, the warranty is null and void. The customer is allowed to make necessary tooling adjustment, replace solder...
-
Page 3: Table Of Contents
Page 3 of 8 Index Summary ........................4 Description ........................4 Accessories ......................... 5 Specifications ....................... 5 Maintenance ........................ 7 6. Parts Lists ........................7 Apollo Seiko Ltd. 2271-7 Jinba, Gotenba, Shizuoka, Japan TEL: +81-(0)550-88-2828 FAX: +81-(0)550-88-2830 E-mail: sales@apolloseiko.co.jp... -
Page 4: Description
Page 4 of 8 1. Summary Adopting the stepping motors has achieved low voltage use. You can use this device safely. ・ Multi power supply allows you using this device AC100V~240V. ・ Sponges can be programmed to rotate forward and reverse by I/O signals. ・... -
Page 5: Accessories
*The customer who purchases our soldering robot and this device at same time, I/O connector is not attached. I/O cable is already attached between the robot and the device. 4. Specifications Type SRC-500DC Dimension 110mm(W) X 95mm(D) X 85mm(H) Number of Sponge Rotation Approx. 45rpm Power Supply AC100V～240V... - Page 6 Unused Wiring Example Clockwise and Counterclockwise I/O such as PLC, Robot, etc. SRC-500DC (Forward) (Reverse) ・ It requires 6.25mA to run the internal relay for CW or CCW rotation. ・ Although +24V and 0V COM are assigned as shown above diagram, you can wire reversely, because there is no polarity.
-
Page 7: Maintenance
Page 7 of 8 5. Maintenance Please turn off the power, when you replace sponges. *Please use the moisten sponges. Sponge(SRC-5006) replacement Loosen the two cap After removing the two Remove the two back sponges, screws. front sponges, remove then insert the new sponges in the the scraper bracket. -
Page 8: Parts Lists
Page 8 of 8 6. Parts Lists Name Type Detail Sponge SRC-5006 8 pieces Suction Sponge B SRC-3005 10 pieces Solder Residue Scraper 451M-106-1 2 pieces Scraper Bracket 451M-122 Sponge Cap Screw 451-119 Water Cup 451M-113-2 I/O Connector 451M-001 A09 Motor 451M-001 A04...
Need help?
Do you have a question about the SRC-500DC and is the answer not in the manual?
Questions and answers