illuminfx COLOR SELECT PLUS Quick Manuals

QUICK GUIDES
COLOR SELECT PLUS
HOW TO
Add
Lighting Zones
To begin, open up your WiFi 104 APP on your smart phone.
STEP ONE >
find your wifi
After you open your Wifi 104 app, it will default to the 'Device List Interface'
screen. Here it will list all available WiFi 104 modules to connect to.
STEP TWO >
configuring a new zone on the wifi
To the right side of the listed WiFi 104 that you wish to add a zone to, is a
small icon that reads 'Zone'
Select 'Zone' and continue to step 3 of this guide.
STEP THREE >
zone set interface
The 'Zone Set' interface will list all 12 available zones that can be added to
the WiFi 104 system. As default, only ZONE 1 is set to be on.
*Optional - You can name each zone if you wish under the 'Zone name' category by simply
clicking on it and typing whatever you wish the name to be. This can be helpful to remember
which zones are which.
STEP FOUR >
setting up a new zone
To turn on an additional zone, it is important to first set which type of zone
it is. To do this click on the 'Type' button for the zone (ex. Zone 2) and that
will open up the 'Select Type Interface' for that zone. You then simply select
which type of lights you are controlling on that zone from the list it provides.
STEP FIVE>
linking that new zone
Finally, you just need to tell the device to enable that new zone you just set
up. To do this, click the 'LINK' for that zone (ex. Zone 2). This will move the
little slider over, and it will change the color to green.
Finally click on the Back button (labeled Return on the diagram).
*As shown in the Zone Set Interface diagram, a Zone that is turned off with have the slider to
the left and it will be grayed out.
The Color Select Plus system allows for additional zones to be added to the WiFi
104 system. Each zone requires a zone controller (CSP-R45ACV) to be added to the
system. This guide will help get these zone controllers integrated into the WiFi 104.
104 '
device on the device list interface
104
Setting up Additional Zones
'