JENTNER Picco+ Manual

Pin electroplating device Picco+
1. General information
1. Carefully unpack the device. Watch for damage. Damages must be reported to the supplier
immediately.
2. Read the user manual thoroughly and carefully. The operator shall ensure that each user
of the appliance has read the instructions carefully before putting it into service.
3. Keep the instructions in a place accessible to all users.
2. Commissioning of the device
The device has been tested by us for its perfect function and has been carefully packaged.
Please unpack the device carefully. Set it up at working height. Plug the power plug of the
device into the wall outlet.
Construction of the device:
Rectifiers
Electrode pin with cable
Cable with goods terminal
1. Connect the plug of the electrode pin (red) to the red socket of the device.
2. Connect the cathode cable plug (black) to the black socket of the device.
Note: Only the amount of electrolyte needed for the electroplating process should be used.
3. Preparation and procedure
3.1 Cleaning of the goods
• The product to be galvanized must be cleaned well, the following procedure is recommended:
-
Ultrasonic cleaning
-
Electrolytic degreasing
-
Drying