Briggs & Stratton Brute YTL-140-473 Instructions & Assembly page 8

STEP 3: Attach the Beam Assembly
1. Attach the beam assembly (#17) to the hydraulic reservoir and secure using the hitch pin (#18)
and R Pin (#21).
STEP 4: Attach Engine
1. Place four polyurethane blocks (#81) and large flat washer Ø10 (#80) in the mounting plate.
2. Position the engine (#33) over the blocks and washers, secure it to the mounting plate, then
put the hex bolt M8x65 (#46) through the bottom of the plate (bolt should go through block, flat
washer and engine base). Place a Flat Washer Ø8 (#36), Lock Washer Ø8 (#32) and tighten
with Nylon Lock Nut M8 (#31).
3. Attach the clear oil pipe (#53) to the bottom of the gear pump and secure with clamp (#51).
- 8 -