Philips 40PFL4907 User Manual page 14

9
Press OK to finish Settings assistant.
Store your preferences.
Cancel
• Network updates will appear after Connection test succeeds.
Use ◄► to select Yes, then press OK.
• When the initial setup is completed, the lowest memorized
channel with the confirmation message of the location setting
will be displayed on the TV screen.
Note
• If you are not receiving a signal from your cable service, contact the Cable provider.
• If you press during AutoProgram, this setup of TV channels will be canceled.
• The initial AutoProgram function can be executed for either Antenna or Cable only
once. When you change the connection (Antenna / Cable), set Autoprogram again.
p. 37
➠
After an initial setup is completed...
• If you want to scan the channels automatically again.
Autoprogram
• You can add the desired cable and Analog channels
unmemorized by AutoProgram.
Weak channel installation
• If you want to change to another language.
Language
• If you want to change the country setting.
Country
• If you want to change the location setting.
Location
• If you want to change the network setting.
Network
• If you want to restore the picture setting.
Settings assistant
Store
p. 37
➠
p. 37
➠
p. 36
➠
p. 19
➠
p. 38
➠
p. 40
➠
p. 30
➠
14
English