Advertisement
2. While another person lifts the back of the Frame (1)
slightly, attach the Rear Stabilizer (30) to the Frame
with two MIO x 75ram Carriage Bolts (33) and two
M 10 Black Nylon Locknuts (34).
3. Attach the Handlebar (15) to the Upright (13) with two
M10 x 42mm Button Bolts (6), two M10 Split Washers
(46), and two M10 Black Nylon Locknuts (34).
4. The Console (16) requires three "AA" batteries (not
included); alkaline batteries are recommended. Insert
three batteries into the Console as shown. Make sure
that the batteries
are oriented
as shown by the dia-
gram inside the Console.
5. Hold the Console (16) near the Upright (13). insert the
console cable and the console wire into the indicated
hole and down through the Upright. Attach the ground
wire to the Upright with an M4 x 16mm Screw (32).
Insert the excess wire and cable into the Upright (13).
Attach the Console (16) to the Upright with four M4 x
16mm Screws (32). Make sure that the wires and
the cable are not pinched.
2
4
5
34
30
1
34
Batteries
Ground
Console
Console
Wire
Cable
5
Advertisement
