Advertisement
MEASUREMENTS AND ADJUSTMENT
ae AZIMUTH ALIGNMENT
Test equipment connection is shown in figure.
.
Playback test tape QZZCAC. (10 kHz, —20 dB)
Speaker
.
Adjust screw ® for maximum
indication for equal output
Terminals
on both channels.
_ After alignment,
lock the head
adjust screw
@
with
lacquer.
VTVM
OSCILLOSCOPE
ERASE BIAS ALIGNMENT
1.
Test equipment connection is shown in figure.
2.
Place unit into TAPE position.
3.
Place cassette deck into recording mode.
a
4. Adjust VR803 for 10.5V +0.5V on VTVM.
(TP801)
(TP802) o
KN Blade
'Screwdriver
TAPE DECK SERVICE AID
When the cassette tape is caught around the capstan
shaft:
Remove 7 screws on the cabinet, and open the front panel,
then turn the flywheel counterclockwise.
Front Panel
Advertisement
