Summary of Contents for KLOPPENBERG DISP-500
- Page 1 DISP-500 Manual 2627 West Oxford Avenue, Englewood, Colorado 80110 ● (303) 761-1615 ● www.kloppenberg.com...
- Page 2 PARTS 2627 West Oxford Avenue, Englewood, Colorado 80110 ● (303) 761-1615 ● www.kloppenberg.com...
- Page 3 Door / Chain Cover Safety Switch 3080001 Angled Front Auger Bracket (Front) 4080008 S/S Ice Chute Assembly 3080025 Chain Cover Parts 2750004 GASKET - SHOVEL DOOR, 4 SIDED 4030009 GASKET (BIN) 1.5 2627 West Oxford Avenue, Englewood, Colorado 80110 ● (303) 761-1615 ● www.kloppenberg.com...
- Page 4 2400083 Flange Bearing 2400088 Gear Reducer 2400066 1/2 HP Motor DISP-500 4080005 Agitator Assembly 4080006 Auger Assembly (Rear) 1800025 Enclosure (electrical box) 2005113 Copper Drain Pipe Parts 2627 West Oxford Avenue, Englewood, Colorado 80110 ● (303) 761-1615 ● www.kloppenberg.com...
-
Page 5: Electrical Parts
Fuse - 2Amp, 250V, AGC Series www.kloppenberg.com 4080013 Door / Chain Cover Safety Switch 1800030 Transformer 120v Input 24v Output DISP-500 1800009 Power Supply Cord 8’ (Electrical) Parts 2627 West Oxford Avenue, Englewood, Colorado 80110 ● (303) 761-1615 ● www.kloppenberg.com... -
Page 6: Installation
INSTALLATION 2627 West Oxford Avenue, Englewood, Colorado 80110 ● (303) 761-1615 ● www.kloppenberg.com... - Page 7 Attach the drain pan using a Phillips head screwdriver to the 2 attachment locations shown and hand tighten. 2627 West Oxford Avenue, Englewood, Colorado 80110 ● (303) 761-1615 ● www.kloppenberg.com...
- Page 8 **DO NOT remove the factory installed copper drain pipe** Removal may void warranty *Ice machine must drain on an independent line. Do not hook up to bin drain lines to prevent backflow. 2627 West Oxford Avenue, Englewood, Colorado 80110 ● (303) 761-1615 ● www.kloppenberg.com...
- Page 9 It is the owners responsibility to manage ice flow in the bin. drain on an independent line. Do not hook up to bin drain lines to pre- *Ice machine must vent backflow. 2627 West Oxford Avenue, Englewood, Colorado 80110 ● (303) 761-1615 ● www.kloppenberg.com...
- Page 10 SERVICE 2627 West Oxford Avenue, Englewood, Colorado 80110 ● (303) 761-1615 ● www.kloppenberg.com...
- Page 11 ***WARNING: HANDLE AND USE NITRIC ACID WITH CARE. FOLLOW ALL MANUFACTURER/SUPPLIER INSTRUCTIONS*** **RECOMMENDATION** To minimize bin contamination, use a water softening system that reduces ferrous minerals and particulates 2627 West Oxford Avenue, Englewood, Colorado 80110 ● (303) 761-1615 ● www.kloppenberg.com...
- Page 12 PEDAL IF NO ICE IS DIS- 10 AMPS. WHEN RUNNING DRY PENSING. BREAK ICE MOTOR MAY SPIKE DUE TO STRESS WITH PADDLE OF PRESSING PEDAL WITH NO ICE 2627 West Oxford Avenue, Englewood, Colorado 80110 ● (303) 761-1615 ● www.kloppenberg.com...
-
Page 13: Troubleshooting
TEST WITH VOLTAGE AMP FUSE, DOOR & CHAIN NOT ALLOW SYSTEM TO OPER- METER COVER SWITCH THIS WILL RESET MOTOR (3) REMOVE CHAIN COVER AND PRESS RESET ON MOTOR 2627 West Oxford Avenue, Englewood, Colorado 80110 ● (303) 761-1615 ● www.kloppenberg.com... - Page 14 4. Supporting the hood with one hand put in the second thumb screw and tighten well. Now tighten the first screw. 5. Check to ensure plexiglass window moves freely up and down. 2627 West Oxford Avenue, Englewood, Colorado 80110 ● (303) 761-1615 ● www.kloppenberg.com...
- Page 15 Line up bins tabs and door tabs. Take vice grips and use to hold bottom of door in place. Then place bushing into the hole. With bushing in position carefully set rivet Figure 3 2627 West Oxford Avenue, Englewood, Colorado 80110 ● (303) 761-1615 ● www.kloppenberg.com...
- Page 16 (Figure 6) Once secure release and test door. Figure 6 Toll Free Phone: 1-800-346-3246 Local Phone: 303-761-1615 Fax: 303-789-1741 Email: sales@kloppenberg.com Please send all PO’s to purchaseorders@kloppenberg.com 2627 West Oxford Avenue, Englewood, Colorado 80110 ● (303) 761-1615 ● www.kloppenberg.com...
-
Page 17: Manufacturer's Warranty
Products must be registered with Kloppenberg within 30 days of installation. Kloppenberg warrants that it will repair or replace at its own expense any commercial ice bin of its manufacture bearing the name Kloppenberg due to a factory defect in material and/or... - Page 18 Kloppenberg assumes no liability for damage of any kind that is a result of alteration or used parts that are not manufactured or approved in writing by Kloppenberg.