Sony VPH-1041Q Operating Instructions Manual page 3

Notice for the Customers in the USA _
INFORMATION
This equipment generates and uses radio frequency energy
and if not installed and used properly, that is, in strict
accordance with the manufacturer's instructions, may cause
interference to radio and television reception. It has been
type tested and found to comply with the limits for a Class B
computing device in accordance with the specifications in
Subpart J of Part 15 of FCC Rules, which are designed to
provide reasonable protection against such interference in a
residential installation. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is. encouraged to try to
correct the interference by one or more of the following
measures:
Reorient the receiving antenna
Relocate the equipment with respect to the receiver
Move the equipment away from the receiver
Plug the equipment into a different outlet so that
equipment and receiver are on different branch circuits.
If necessary, the user should consult the dealer or an
experienced radio/television technician for additional
suggestions. The user may find the following booklet
prepared by the Federal Communications Commission
helpful:
"How to Identify and Resolve Radio-TV Interference
Problems'. This booklet is available from the U.S.
Government Printing Office, Washington, DC 20402, Stock
No. 004-000-00345-4.
The shielded interface cable recommended in this manual
must be used with this equipement in order to comply with
the limits for a computing device pursuant to Subpart J of
Part 15 of FCC Rules.
Projection System Installation Instructions
WARNING: USE OF PROPER HARDWARE AND
ACCESSORIES IS REQUIRED AS SPECIFIED. PROPER
INSTALLATION ACCORDING TO INSTRUCTIONS IS
REQUIRED. IMPROPER INSTALLATION MAY RESULT IN
SERIOUS PERSONAL INJURY.
Notice for the Customers in the United
Kingdom
WARNING
THIS APPARATUS MUST BE EARTHED
IMPORTANT
The wires in this mains lead are coloured in accordance with
the following code:
Green-and-yellow : Earth
Blue : Neutral
Brown : Live
As the colours of the wires in the mains lead of this
apparatus may not correspond with the coloured markings
identifying the terminals in your plug proceed as follows:
The wire which is coloured green-and-yellow must be
connected to the terminal in the plug which is marked by the
letter E or by the safety earth symbol + or coloured green or
green-and-yellow. The wire which is coloured blue must be
connected to the terminal which is marked with the letter N
or coloured black. The wire which is coloured brown must be
connected to the terminal which is marked with the letter L
or coloured red.
Notice for the 'Customers 'in, Canada
This apparatus complies with the Class B limits for radio
noise emissions set out in Radio Interference Regulations of
Canada.