Information For The Installer - AEG FAVORIT 620 Operating Instructions Manual

What can be the cause . . . if something does not work?
The dishes are not dry and sparkling?
@ Did you use a rinse aid recommended by
us?
@ Did you fitl up the rinse aid container?
@ ts the correct quantity of rinse aid being
dispensed?
If too little is used, white/grey water
marks will appear, particularly on glasses.
If too much is used, opaque or blueish
smears will appear, particularly on glasses
and they may even feel sticky.
What can be the cause...
(if something does not work?)
... There are rust spots in the machine?
@ The stainless steel tub, the inner door and
the filters cannot rust. If you find rust
spots, these are introduced with the water
or due to rust on cutlery, Saucepans, etc.
Did you select a rinse and hold pro-
gramme or a complete wash programme
such stains with a stainless steel cleaner.
... If the overflow or anti-flood device
is activated.
@ This dishwasher is equipped with anti-
flood devices.
The machine has an overflow protection
which prevents excess water from entering
the machine and a leakage protection
underneath the machine (a float in the
base of the machine). This float is acti-
vated by any leakage from the appliance.
In both cases an electromagnetic inlet
valve shuts off the water supply to the
machine and the drain pump is switched
on. ;
Flooding from the machine through leak-
age or overflowing has thus been eliminat-
ed. Any remaining water in the appliance
is automatically pumped out.
To diagnose the fault always call your local
AEG Service Department or Agent. after filling the salt container? Remove
Service
Use our check-list on page 12/13 to make sure
you cannot rectify the fault yourself.
@ If you call out a service engineer in connec-
tion with one of the problems listed the cost
involved will have to be passed on to you
even during the warranty period. The same
applies to wrong usage or misuse of the
machine.
e@ Therefore, follow the instructions and recom-
mendations in this booklet carefully.
the problem in spite of the check-list please
contact your AEG Service Department. Do
not carry out any repairs yourself, particularly
electrical ones.
When cailing for a service engineer please quote
the model no. and the serial no. of your machine.
These nos. are printed on the rating plate (fig.
2/G).
Fill in these numbers for your future reference.
E no.
Serial no. (F no.)
@ Should you be unable to locate the cause of a ee ee ee
Information for the installer
Drainage hose
At the rear of the machine the drainage hose is
secured with plastic straps which must be
removed. Route the drainage hose along the
recess provided at the rear of the dishwasher.
When connecting the hose to a similar trap with
an appliance discharge connection it is important
to raise the hose to the underside of the worktop
and secure it in this position with the hose holder
provided. This will prevent water from the sink
entering the machine drainage hose. The outlet . ts
13