Loll Designs AC-RS-CG Manual

ROPE SWING
SWING HANGING SUGGESTIONS
lolldesigns.com 1-877-740-3387
1
3
5
7
2
4
6
8
INSTALL EYE BOLT
Use a branch at least 4˝ in diameter on a healthy/sturdy
tree and tall enough to allow full motion of the swing
(see reverse side for more details).
1
Drill two holes through the center of the branch 20
inches apart and the same diameter as the eye bolt
shank. Insert the eye bolt through the hole and fit the
large washer and locking nut over threads. Tighten nut
down securely.
2
Place quick links through the eye bolts and leave
ATTACH CHAIN/ROPE
3-4
Fit the rope rings into the quick links and thread the
5-6
quick links shut. Check the swing seat for distance
from the ground and that it hangs level. Use a level on
the swing seat for best measurement. If the seat does
not hang level, one end is too short and rust resistant
chain links can be added to correct length to level the
seat.
7-8
*Note: If chain links are required an additional quick
link will be required to connect the chain to the rope
loop.