Summary of Contents for Diamond Products CROWN GS32
Page 1
CROWN GS32 AUTO SCRUBBER OPERATOR'S MANUAL IMPORTANT: READ OPERATOR'S MANUAL CAREFULLY Please fill out & return your warranty card! DP80132 Diamond Products www.diamondproductsus.com Printed in the U.S.A.
Page 2
Diamond Products US. Warranty Information Thank you for purchasing a Diamond Products US product. Warranty registration is quick and easy. Your registration will allow us to serve you better over the lifetime of the product. To register your product, email your warranty card information to: info@diamondproductsus.com...
Page 3
4) BEFORE LEAVING OR SERVICING MACHINE: Stop machine on level ground. Turn machine off. 5) WHEN SERVICING MACHINE: Read operators manual thoroughly prior to operating or servicing this machine. Use manufacturer supplied or approved replacement parts. Diamond Products Operator's Manual...
Page 5
3. Tighten the knobs securely. 4. Secure the vacuum hose on the pick-up tube of the squeegee. 5. Apply a coating or protective spray on the cable connections to prevent battery corrosion. DO NOT DROP THE BATTERIES INTO COMPARTMENT! Diamond Products Operator's Manual...
FILLING THE SOLUTION TANK 5. Turn vacuum motor switch to "on" position. 1. The Crown GS32 can only be filled in the (see machine components, item #1) 6. Turn the brush motor switch to "on" position. rear of the machine. There is a fill cap that...
You must first determine what caused the 3. Replace the drain hose plug tightly as soon as you are done draining the tank. breaker to trip, and allow the motor to cool down before you can reset the breaker. The Diamond Products Operator's Manual...
: Batteries are dangerous! Batteries emit hydrogen gas and an explosion or fire can result. Keep sparks and fire away from batteries at all times. When charging the Diamond Products Operator's Manual...
1. Remove pad driver / brush and clean with VACUUM MOTOR MAINTENANCE approved cleaner. 1. Contact your local Diamond Products 2. Drain recovery and solution tanks completely and rinse out with clean water. Visually check Distributor for any motor maintenance.
6. Drain the recovery tank and remove the clear lid on the top of the recovery tank so that it can "breathe" during storage. 7. Drain the solution tank of all fluid. Diamond Products -10- Operator's Manual...
SOLUTION No power Bad batteries Replace batteries Key not in "ON" position Turn key "ON" Contact Diamond Products Distributor Main circuit breaker tripped Batteries need to be charged Charge batteries (see Battery Charging) Loose battery cable Tighten loose cable(s) Batteries not connected properly...
VF14200 SCREW, M6 X 16 VF84113 HINGE, RECOVERY TANK VF83143 LOGO (32") VA13477 SCREW, SELF-TAPPING, ST, M4 X 16 VV13664 WASHER, PLAIN, M4 X M12 X 1 VF82010A RUBBER HINGE VF82010B GASKET VF82010-X KIT, LID Diamond Products -19- Operator's Manual...