Denon DRM-400 Operating Instructions Manual page 8

REC/REC MUTE ~. REC PAUSE BUTTON
REC/REC MUTE is the DENON's unique and convenient
function, which can set up both REC PAUSE (standby) and
REC MUTE (non-signal recording) modes by a single button
By using this button, it is easily possible to insert a suitable
space (the non-recorded part) between two melodies..
1. When you want to make about 5 sec of non-recorded
part after the recording state:
Press the REC/REC MUTE button. The recorder will auto-
matically create about 5 sec of non-recorded part and
will stay in the recording standby state.
2. To create about 5 sec of non-recorded part after the
standby state:
TAPE COUNTER AND MEMORY STOP
PEAK LEVEL METER
LEFT INNOOO O90 0O0 oop ofp ooo RECORD
5 w +s +6
RIGHT JNNHH O00 N00 000 of0 ooo om ae
MEMORY STOP
[ ae
a ee5oee -10
MEMORY DOLBY NR
ON/OFF
1) Operation of the Tape Counter
(1) Press the RESET button to reset the counter to
"000".
(2) By using the PLAY, FF, or REW function, the reading
of the counter will change to indicate index position.
eDuring recording and playback operations, the
counter is useful for noting the location of existing
Programs or positions where recording is to be
started.
Press the REC/REC MUTE- button, and the recorder will
enter the non-recording state, automatically create about
5 sec of non-recorded part and stay in the standby state.
3. Tocancel the non-recording state (the REC MUTE state):
Press the REC PAUSE button, and the recorder will cancel
- the non-recording state and will stay in the standby state.
4. To extend the non-recording state (the REC MUTE stats)
for further 5 sec or more:
Press the REC/REC MUTE button, and the non-recorded
part will automatically be extended for another 5 sec.
B-NR C-NR MPX FILTER
{ mee | co fame]
2) Operation of MEMORY STOP
(1) During recording or playback operations, MEMORY
STOP can be used to focate a particular point on
the tape. At the desired point, push the memory
button. The deck will stop at the desired point
during REWIND operations.
(2) The MEMORY STOP indication will lignt when this
function is activated.
Note :
e When the power is turned "OFF", this function
is automatically deactivated.