Table of Contents
Advertisement
Quick Links
Quick Start Guide
UPS-100 Quick Start Guide
General Layout
1 - Remove Back Plate by removing the 4 nuts and washers (1 in each corner)
G2 Security PTY Ltd
1- Inverter
2 - UPS 220V Output
3 - 220V Input
4 - Battery Location
5 - Positive Battery Terminal
6 - Negative Battery Terminal
7 - Battery Fuse 20A
8 - Charge Controller
UPS-100
Page 1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for G2 UPS-100
- Page 1 Quick Start Guide UPS-100 UPS-100 Quick Start Guide General Layout 1- Inverter 2 - UPS 220V Output 3 - 220V Input 4 - Battery Location 5 - Positive Battery Terminal 6 - Negative Battery Terminal 7 - Battery Fuse 20A...
- Page 2 (inside the accessory pack attached to the battery leads) NOTE only use LIFePO4 batteries as this is what the charge controller has been programed to charge, It is not suitable for Lead Acid Batteries The LED lights of the charge controller will come on. G2 Security PTY Ltd Page 2...
- Page 3 Once you are ready to power up the attached equipment you can switch the inverter (1) switch to the ON position where it indicates with 1 |. Do not switch to 2 bar || symbol as this is the incorrect setting and may not power your fire panel. G2 Security PTY Ltd Page 3...
Need help?
Do you have a question about the UPS-100 and is the answer not in the manual?
Questions and answers