Advertisement
Quick Links
Advertisement
Related Manuals for CellGate Omnipoint
Summary of Contents for CellGate Omnipoint
- Page 1 Omnipoint Gateway Hardware Guide ® CellGate Support: 972-231-1999, opt. 2...
-
Page 2: Weather Protection
Mount and Secure Kit To mount and secure the kit to the enclosure and pole, follow the steps below. 1. Fix the cross bracket on the bottom of the enclosure with 4 M6*12 bolts. 2. Place 2 pieces of the clamp around the pole and tighten them with M6*110 bolts, washers, and nuts. - Page 3 2. Cut off 50 cm (roughly 20 in) of waterproof tape. Stretch the tape to 100 cm (roughly 40 in). Wrap 3 layers around the connector with a 50% overlap. Using your hand, hold the tape in place for a few seconds. 3.
-
Page 4: Device Protection
Device Protection Indoor and outdoor systems require lightning surge protection. See below: Outdoor Surge Protection System Antenna Grounding We recommend installing a lightning arrestor on all antenna N-Type terminals (LoRa, LTE). Use 10AWG or greater grounding wire to connect the arrestor to the tower-mounted LoRa antenna. The arrestors must be Female to Male to fit the antenna and housing connectors. - Page 5 Lightning Controller You must use the lightning controller on your on your Gateway. If you do not the device can be damaged by lightning. If you do not use the lightning protector, you devoid warranty for your device. The lightning controller is to the right. The lightning controller arrives with protective blue caps.
-
Page 6: Attach Antennas
Attach Antennas VPN (Internet Mode) LoRa The number and location of antennas to attach to your Omnipoint device depends on whether you use an Omnipoint Cellular device or an Omnipoint VPN device. See below for further details. Cellular For the cellular device, you can attach the main antenna. You can also attach an antennas to LTE- DIV\LoRa2 and you can attach a different antenna to LTE-MAIN as shown below. - Page 7 Connection You must open the Gateway device to set up the set up the device correctly. These actions need apply to the connector--see the example to the right. 1. Unscrew the top of the connector. 2. Connect the Gateway as shown: •...
-
Page 8: Gateway Status
Gateway Status To use the Omnipoint successfully, verify the Gateway is online. Do not power on Gateway until antenna has been installed. When you log in, you can see whether the Gateway is online or offline.