Remote Control Functions For Peripherals; To Select Connected Equipment; Audio And Video Equipment Keys - Philips 32PW9556-57R Manual

TV VCR DVD
TUNER CD TAPE
S
MOVIE SPORT CHILD NEWS
æ
TV VCR DVD
TUNER CD TAPE
S
æ
OK
1 2
4 5
7 8
0
ZOOM
INSTANT
INSTANT
Connect Peripheral Equipment
24

To select connected equipment

SAT
CDR
Q
OTHER

Audio and video equipment keys

VCR
SAT
CDR
Q
MENU
P
3
6
9
If the TV is connected to a video recorder with the EasyLink function, in some cases
the TV will be switched on, even when it was in standby. (E.g. playback tape,...)
This is not possible when Child lock On is selected.
Equipment connected with an aerial cable only :
Select the programme number under which you have stored the test signal
with the digit keys.
Equipment connected to a euroconnector or to the front side of
the TV
Press the key repeatedly to select
according to where you connected your equipment at the back or the front
side of your TV.
Remark : Most equipment (decoder, video recorder, satellite receiver) carries out the
switching itself when they are activated.
If you want to change to TV channels?
Enter the programme number of the TV channel which you want to watch
with the digit keys or press the
Most of the audio and video equipment from our range of products can be
operated with the remote control of your TV.
Press the , ,
VCR DVD SAT,TUNER, CD,TAPE
equipment you want to operate with this remote control. See Use of the
remote control, p. 8.
Video recorder
Press one of the video recorder keys after you pressed the
for record,
for rewind,
for stop,
for play,
for fast forward,
for selecting 1- or 2-digit programme numbers from the video
recorder,
- P + for fast programme selection from the video recorder tuner,
0 to 9 to select a programme number from your video recorder tuner,
to switch the video recorder to standby
VCR timer
These keys function with equipment which use the RC5 signalling standard.
If your video recorder has the EasyLink function, the key
under the door of the remote control, can be operated in the TV mode.
If your EasyLink video recorder has the system standby function, press the
3 seconds to switch both TV and the video recorder to standby.
, or
EXT1 EXT2, EXT3 FRONT
key repeatedly to select TV.
or key according to the
CDR
VCR
INSTANT
,
key:
for recording,
key for