Advertisement
Table of Contents
INSTALLATION MANUAL
TIS KNX GATEWAY
KNX Standard Communicator
Model: TIS-KNX-PORT
Inputs
KNX Bus (EIB)
TIS
Bus``
Functions
Connection terminal
Dimensions
Housing
P R O D U C T S P E C I F I C AT I O N S
KNX
TIS
Bus voltage
Current Input, EIB
Power Consumption, EIB
Protection
Number of devices on 1 line
Bus voltage
Current consumption
Protection
TIS->KNX
KNX->TIS
KNX Bus
TIS Bus
Width × Length × Height
Materials
Casing color
IP rating
PRODUCT INFORMATION
This
product
is
a
designed to integrate and synchronize devices
working on TIS and KNX standard for maximum
automation and convenience.
KNX network 2 wires connection
TIS-BUS (RS485) 4 wires connection
21-30 VDC via the EIB bus
<12mA
<360mW
2000V ESD protection
Max. 64
12-32 V DC
<50 mA / 24 V DC
Reverse polarity protection
Control lights ON/OFF, dimmer and shutter
Control lights ON/OFF, dimmer, shutter, infrared and air condition
Screw terminal 0,2...6mm2
Screw terminal 0,2...4mm2
36mm × 64mm × 90mm
Fireproof ABS
Gray
IP 20
networking
convertor
Advertisement
Table of Contents
Related Manuals for TIS TIS-KNX-PORT
Summary of Contents for TIS TIS-KNX-PORT
- Page 1 TIS and KNX standard for maximum automation and convenience. P R O D U C T S P E C I F I C AT I O N S KNX network 2 wires connection...
-
Page 2: Safety Instructions
SA , AUSTRALIA Wanchai, Hong Kong TIS Logo is registered trademark of TIS CONTROL. All of the specification are subject to change without notice. w w w . t i s c o n t r o l . c o m... -
Page 3: Installation Steps
SA , AUSTRALIA Wanchai, Hong Kong TIS Logo is registered trademark of TIS CONTROL. All of the specification are subject to change without notice. w w w . t i s c o n t r o l . c o m... - Page 4 SA , AUSTRALIA Wanchai, Hong Kong TIS Logo is registered trademark of TIS CONTROL. All of the specification are subject to change without notice. w w w . t i s c o n t r o l . c o m...
-
Page 5: Troubleshooting
INSTALLATION MANUAL TIS KNX GaTeway MODEL : TIS-KNX-PORT TROUBLESHOOTING Reason: Device is not powered on; no TIS- Device PRG LED is not Blinking; BUS 24V nor KNX Power supply connected Device not Powered to the device. Reason: Assigning the physical address on Device PRG RED LED is blinking process.
Need help?
Do you have a question about the TIS-KNX-PORT and is the answer not in the manual?
Questions and answers