Advertisement
ADJUSTMENTS:
-2-
Figure
2
When attaching
the
34!t
Snowblower to the Westchester
Tractor,
con-
nect the
control rod to
the top sprocket-housing shaft with one
of
the two
rubber
connectors
provided,
and use two
of the four elamps provided.
Mount the
control crank
support bracket to the Westchester
left
side
body
hinge pivot point by removing the body hinge
pivot bolt
and
installing
the
special locking bolt included with the Snowblower. Include the spacer be-
hveen the
crank
support bracket and the Westchester
body.
Pass the crank
through the
crank
support bracket and mount the crank
to
the
control rod
with the
second
rubber
connector and the remaining two clamps.
NOTE:
If
the Snowblower
is
uneven
with the ground
after
mounting on
traetar,
check the
air
pressure in the ttactor
tires.
Discharge
Chute
To position the Discharge Chute,
turn the control
crank.
The
Dis-
charge Chute
will
rotate approximately
165
degrees
from
extreme
left,
through the
vertical position, to
the extreme
right.
As the crank
is
turned,
the deflector opening
is
also rotated
from
the extreme }eft position through
a
forward position approximately
180
degrees to the extreme
right
position.
Deflector
To provide
accwate
placement
of
the blown snow near the blower on
Advertisement
