Denali MA11768 Manual

Denali MA11768 Manual

Plow mount for cfmoto u-force 1000

Advertisement

DENALI Plow Mount
Thank you for purchasing our DENALI plow mount. You now own a premium
custom plow mount to allow you to use your plow with your SxS. Please note the
following instructions and heed all warnings.
• Your UTV/SxS and/or plow system can cause death or injury, please use
caution and common sense when operating your unit.
• Read your Plow Operator Manual, your Winch Operator Manual, and all
warning labels before operating your UTV/SxS.
• Operate your UTV/SxS at a walking speed with the blade installed. Do not
exceed 5 mph (8 km/h), even with the blade up.
• Do not operate the UTV/SxS on slopes greater than 10 degrees with the
plow installed.
• Always lower the plow to the down position before leaving your UTV/SxS
unattended.
SEVERE INJURY OR DEATH MAY RESULT IF YOU ARE NEGLIGENT.
866.527.7637
MA11768
CFMOTO U-FORCE 1000
1
motoinfo@motoalliance.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MA11768 and is the answer not in the manual?

Questions and answers

Summary of Contents for Denali MA11768

  • Page 1 DENALI Plow Mount MA11768 CFMOTO U-FORCE 1000 Thank you for purchasing our DENALI plow mount. You now own a premium custom plow mount to allow you to use your plow with your SxS. Please note the following instructions and heed all warnings.
  • Page 2 Rogers, MN 55374 866.527.7637 Please verify that all hardware and parts are included in your package. Kit Contents: Item Number Quantity Part Number MA11768 Mount MA11768 U-Bracket Hex Bolt M8x1.25x35 Plain washer, 8mm, narrow M8x1.25 Nylock Nut Figure 1 866.527.7637...
  • Page 3 MA11768 22000 Industrial Blvd, Ste 250 Rogers, MN 55374 866.527.7637 MA11768 Plow Mount Installation Note: Only use hand tools. 1. Remove two M6 bolts located at the front of the skid plate, as shown in Figure 2 Figure 2 2. Put M8 bolts to U-bracket and mount loosely.
  • Page 4 CF-Moto U-Force 1000 MA11768 22000 Industrial Blvd, Ste 250 Rogers, MN 55374 866.527.7637 3. Fit the U Bracket over the frame of the machine, as shown in Figure 3 Figure 3 866.527.7637 motoinfo@motoalliance.com...
  • Page 5 CF-Moto U-Force 1000 MA11768 22000 Industrial Blvd, Ste 250 Rogers, MN 55374 866.527.7637 4. Secure the mount using the two (2) M6 bolts that were removed from skid plate and tighten all bolts, as shown in Figure 4 Figure 4...

Table of Contents