AEG OKO FAVORIT 645 Operating Instructions Manual page 20

Information for the installer
Installation
The appliance must stand level and on a firm
floor. The floor should be clean and free from
floor polish and grease. The appliance has
adjustable feet. If necessary adjust feet.
Should a freestanding machine be built under
a worktop in a built-in kitchen, the table top of
the machine can be removed. In this case you
need to protect the underside of your kitchen
furniture worktop at the front with an aluminium
foil strip which is available as an optional extra
from AEG Spare Parts Department. You will
find details how to secure the aluminium foil
strip on the back of the strip. This is the only
way your worktop will be protected against
steam being emitted when the dishwasher
door is opened.
To comply with Safety Regulations, the
machine must be installed in such a way that
there is no access to live parts or internal
connections with functional insulation.
Please note
(this applies to free-standing appliances with
worktop only)
Should a dishwasher be installed next to a
gas, solid fuel or electric cooker due to lack of
space, a heat insulating panel (85 x 57.5 cm)
has to be fitted, the side facing the cooker has
to be lined with aluminium foil.
Water supply
To protect the drinking water supply system
your dishwasher is fitted with an anti-syphon.
A connection to a hot water supply up to a
maximum of 60 °C with a minimum pressure of
1 bar is possible, although the machine must
not be connected to single outlet instantane¬
ous electric or gas heaters.
If the water pressure is below 1 bar consult
AEG Technical Department.
Please ensure you comply with the drinking
water regulations of your local Water Bord.
The high pressure hose with %" hose
coupling complete with sealing washers is
supplied. We recommend not to use other
washers which may be of inferior quality. It is
sufficient to tighten the nuts by hand.
The machine may be connected:
a) directly to a tap with W BSP thread
termination
b) to a T-junction on your existing tap, or
preferably
c) to a completely seperate water supply in
order to avoid interference with the kitchen
water supply during operation of the
machine
Minimum water pressure: approx. 1 bar pres¬
sure above atmospheric pressure (1 atu =
approx. 1 kp/cm2 = approx. 10 N/cm2. For less
than one bar of pressure above atmospheric
pressure, consult the AEG Technical Depart¬
ment. Maximum permissible water pressure:
approx. 10 bars. For over 10 bars excess
pressure, connect a pressure relief valve
(obtainable through your installer).
If a longer water supply hose is needed It
should be a single run of high pressure
hose available in two lengths (3.50 m
E-No. 645 430 552 and 5 m E-No. 645 430 553)
from AEG Spare Parts Department. Never add
extensions to hoses. Turn off the water tap if
the machine is not in use.
20